Autowatch Ghost II Immobiliser Review

Autowatch ghost immobiliser range rover immobiliser is the next generation in car security. It is undetectable by thieves and is impossible to start without a unique pin code or app authorization.

The system is based on your vehicle's CAN Data network and is inaudible and therefore cannot be identified by common thieves' radio signals or diagnostic tools. It also does not require any circuit cuts to install.

What is a Ghost Immobiliser?

A Ghost Immobiliser is a device that protects your car from theft by blocking the engine from starting until you enter a specific pin code. It can be utilized on a wide variety of vehicles, and unlike other immobilisers, it doesn't require a key or fob to operate. It is also very difficult to hack or bypass and works silently, meaning a thief would need to be quick to get away without being noticed.

It is protected from signal jamming, spoofing and key cloning, all of which thieves have used to unlock cars equipped with standard immobilisers. The device stops thieves from stealing keys by snatching them in your mailbox, or entering your home and stealing the remote control. It can even stop them from stealing your joy and pride in the event that they are able to steal the key, because it stops them from starting your vehicle without entering a code first.

A ghost immobiliser, in contrast to passive immobilisers, which require a key or fob to be in use to activate it, is designed to be completely sealed inside the engine. It is directly connected to the data circuits of the CAN in the vehicle. The system generates a pin code when you press buttons on the steering wheel or the console of your vehicle. You must enter this code before the engine can start. The system can be switched into a service mode, which allows your car to drive and start for short periods of time without needing an PIN code. However, the service mode will end according to speed and time.

Because of the technology employed this device is not able to be bypassed or hacked, even with the use of advanced equipment like codes grabbing or RF scanning devices. It is also impossible to disable using an ordinary vehicle immobiliser since it doesn't send signals as a standard immobiliser does and only connects directly to the CAN data circuit.

Because of its advanced technology and ease of installation, the ghost immobiliser ghost installer - address here - immobiliser has been insurance Approved by TASSA (Tracking & Aftermarket Security System Association). We are a proud TASSA approved Ghost installer and can install the device in your vehicle for insurance purposes.

What is the Ghost Immobiliser Work?

In simple terms, an immobiliser works by preventing your vehicle from starting when the wrong fob or key is used. This is accomplished by sending a code to the vehicle's ECU (Engine Control Unit) If this code is sent by the wrong fob or key the ECU won't recognize it, and consequently the car won't start. This is why it's vital to ensure that your car is fitted with an immobiliser installed by an established and trusted specialist.

At MotorGuard, we are the Midlands' leading security experts and installers for vehicles. We offer an Autowatch Ghost immobiliser fitting service for a wide variety of modern vehicles and you can be assured that your pride and joy is safe from thieves.

The Autowatch Ghost is the first aftermarket CAN-bus immobiliser in the world. It shields your vehicle from key cloning and hacking as well as theft. It's designed to remain undetected by thieves because it doesn't have LED indicators or key fobs, and can be hidden within the wiring of your vehicle so that no extra hardware is needed.

After installation, the system is linked to the CAN system in your vehicle and allows you to design a an exclusive disarm sequence that includes your own pin code which you must enter in order to drive the vehicle. This pin code is up to 20 presses long for added security. If you have forgotten your pin code or if the button is broken, there is a secure emergency code that you can use. This will let your vehicle to restart.

It is because the Ghost immobiliser isn't able to be bypassed or hacked that it's such a deterrent to thieves. In addition, it is also TASSA insurance-approved (Tracking and Aftermarket Security Systems Association) which can help reduce the cost of your car insurance.

As technology continues to advance and improve, ghost immobilisers are becoming more sophisticated. For this reason, we recommend contacting an Autowatch Ghost immobiliser fitting service as soon as possible to ensure that your pride and joy is fully protected. If you're looking to purchase a brand new car, or are looking to upgrade your existing car, you can trust us to provide you with quality service, so you can feel confident in your pride and joy for many years to come.

Is the Ghost Immobiliser compatible with my vehicle?

The Ghost is the first aftermarket CAN bus immobiliser system that provides complete protection against modern car theft. It provides protection against key cloning and vehicle hacking, as well as ECU swapping. The TASSA-verified Ghost-II system also provides vehicle marking, linking to the International Security Register and enabling your insurance company to confirm that you have an Ghost system installed.

Our Ghost Immobiliser prevents thieves from starting your engine by needing an unique pin code sequence to be entered or the presence of your phone with our Autowatch app downloaded before it can be used. It functions as a PIN for a bank card and makes it impossible to drive away with your joy and pride without entering the correct pin or phone. Our Ghost Immobiliser System is integrated into the CAN Data Network so there is no wire cutting needed and the system is completely silent. It is unnoticeable to thieves and can't be detected by the sophisticated RF scanning and code grabbing technology which other systems use.

After the Ghost is installed by our trained fitters it is completely concealed and inaccessible to the naked eye. it makes use of the buttons on your vehicle, for instance on the steering wheel, door panels, and the center console to generate a unique pin code sequence which must be entered before the engine can start, much like a password for your bank account. Then, it is linked to your smartphone via the Autowatch app to allow you to switch into the temporary 'Service or Valet' mode which disables the ghost for up to 30 minutes as you hand over your vehicle for service or transportation.

With the high level of personalisation and modification employed in today's vehicles, along with the fact that a majority of us are driving older vehicles it is no surprise that the amount of stolen vehicles has increased dramatically. Many of these are expensive and scarce vehicles that can take months to repair after being stolen. Hence, making sure that your pride and joy isn't in danger of becoming the next target is crucial. Ghost immobilisers are a low-cost investment that can help protect your vehicle and even be used to retrieve the vehicle in the event of theft.

Does a Ghost immobiliser work by cutting principle?

Ghost immobilisers prevent the engine of your car from starting unless an additional PIN is entered with your key fob. This stops thieves from cloning car keys or hacking the computer system in your car. It can also encourage them to leave the vehicle unattended.

Once installed your ghost immobiliser generates an individual pincode that can be up to twenty digits, which you can enter using the buttons on your vehicle (steering wheels, centre consoles or door panels). This code has to be entered to start your vehicle. This code sequence is required every time you want to drive your car as the PIN or password on a bank card. The code can be easily reset by entering a number sequence in the Ghost app.

The Autowatch Ghost II CAN has two deactivation options for valet and services, which allow you to temporarily start your car without having an access code - similar to the keyfob - when it is in the garage or at valet parking services. The immobiliser will be activated when your vehicle is placed in a garage.

Contrary to other security devices available and in comparison to other security devices, the Ghost is completely undetectable to modern criminals since it doesn't feature any LED indicators, and it operates silently using your vehicles CAN data network. It is also not prone to the same types of circuit cuts that are found in other security devices, since it does not rely on radio waves.

It can also be hidden and discretely installed, making it difficult for thieves to discover. It is also unnoticeable by sophisticated scanning tools and code grabbing technologies that are commonly employed to identify or disable security devices.

The Ghost is a sophisticated, high-quality CAN bus immobiliser. It provides excellent protection against key cloning and relay theft, as well as car hacking. It's easy to install and is inaccessible to thieves. It can't be removed by simple wire cutting. This makes it a must for any driver who wants to safeguard their vehicle.