Fiat 500 Replacement Key Fob

If your 500 remote key fob isn't functioning, it could be time to replace the battery. If you replace the battery but it's still not working it could be a problem somewhere else.

At United Locksmith, we specialize in the creation of new keys for classic automobiles. We have all of the tools and accessories needed to provide this service.

Dead Coin Battery

The most common reason why your Fiat 500 key fob will not lock or unlock the doors is a dead battery. The key fob contains the battery of a coin-cell that is prone to draining quickly if it is not frequented enough. If your remote started to show signs of weakness such as a loss of range, and then stopped working completely the battery could be dead.

The battery in the key fob is held in place by metal clips that retain it. If the clips are loose they could cause contact issues, fiat punto replacement key which could prevent your remote from receiving power. Use a flathead screwdriver open the retaining clips and then remove the old battery. Make sure to select a replacement battery with the same type of voltage, dimensions, and specification as the original battery.

Water exposure can also cause the key fob to corrode, or even become damaged. Even a brief bath in warm, soapy water could damage the chip. Make sure your key fob is dry.

Water Damage

If your key fob isn't working correctly, it could be due to water damage. Key fobs are fitted with rubber seals that protect them from being damaged by rain or splashes of water, however it is very important to keep your car keys out of the pool, ocean, and the washing machine!

The key fob is equipped with an electronic chip which sends an electronic message to the immobilizer of your car. The chip is what allows the 500 to be locked and started. If it gets wet, however it will not work.

If you're trying to determine if your key fob is still functioning You can clean the internal electronics with isopropyl or electronic cleaner. It is best to replace the key fob if it's submerged in salt water instead of trying to repair it yourself.

A replacement fob could cost you some money however, it's less expensive than paying to have your fiat punto locked keys in car 500 towed to a dealership and fixed there! You could also do it yourself by following a few simple steps. Make sure you have the correct type of battery before attempting to open your keyfob. This is a job that's far simpler than it appears, and you can find step-by-step instructions online for almost any key fob for your car.

Faulty Chip

The chip in the key fob communicates to your car's immobiliser unit to make sure your car is only capable of starting when the correct key is used. If the chip is damaged or damaged in any way it will not start.

A chip that is defective can happen due to a variety of reasons, but most often it is due to water damage or a dead battery. Whatever the reason, it's a good idea to leave this task to a locksmith as they will be able to replace the chip for you quickly and at an affordable price.

If your key fob does not work after exposure to clean rain or tap water, remove the battery. Wipe down the electronic component with an old towel. If the key fob isn't working, it is likely to be a damaged chip that must be replaced.

Some people will visit their dealer if they require a new Fiat fob. However, this could be an expensive option. United Locksmith is the best option if you would like to have your fiat Punto Replacement key keyfob fixed at a reasonable price. We have all the tools and experience needed to repair your Fiat fob quickly and professionally. manner.

Faulty Receiver Module

Fiat key fobs transmit an electronic signal to the vehicle which will unlock and close doors (and start the car for vehicles with an automatic transmission) up to 50 feet. However, there are a few things that can cause the fob to cease working. This could be due to a dead battery, water damage, worn out buttons, a receiver issue, signal interference or malfunctioning chips.

If the fob was located in the pocket of someone who has suffered severe trauma (such as being dropped onto the hard floor or washed in a washing machine), it may not be in a position to connect with the Body Control Module (BCM) of the vehicle. This is because the BCM is a secure system that can only accept a signal from a genuine original key and not any other.

If this is the case, then you will require replacing your fob. A professional locksmith can take care of every aspect of the replacement process, including programming a new one for your 500. They can even give you an clone fob that performs exactly the same way as the original (and costs only a fraction of the cost).