Peugeot 308 Key Fob Replacement

Peugeot's 308 might be catching on a little but it's still appealing. It's not the most luxurious car in its class, but it's an enjoyable and relaxing drive.

We get asked frequently at Coded Car Keys to replace peugeot key fobs. No matter if the issue is constant or intermittent the following tips will assist.

Water Damage

If you accidentally drop your key fob into a puddle or it is soaked while kayaking, canoeing, rafting, or canyoning it is likely to be damaged by water. The best way to stop this from happening is to always keep it in a dry container when you're out in the open or engaging in activities in which the fob may be exposed to high levels of water.

It's also important to make sure the fob has completely dried out prior to opening it up and then use it again. If you notice any smells from the fob (such as industrial liquid or windshield washer fluid), this is another indication that it's submerged.

A circuit board that is wet could cause the battery to discharge its charge or even explode. If you're able fish the 308 key fob from the body of water it was stuck in then flip the button side down and shake it out as much water as possible before opening the case. When you've opened it, take off the battery, and then clean the circuit board with an abrasive soaked in 90-percent isopropyl alcohol.

Other reasons your Peugeot 308 remote keyless entry system might stop working include an empty coin battery problems with the receiver module, signal interference, or an electronic chip that is defective. If none of these are the problem it is possible to reset the system by disconnecting a 12 volt battery from your vehicle for 15 minutes.

Dead Coin Battery

Peugeot cars come with remote start technology which allows drivers to start their vehicle from some distance, which allows them to warm up or cool down the vehicle before entering. This feature is extremely beneficial, especially during cold winter months. Remote start systems can not function due to a variety of reasons, such as the battery being dead.

The coin-shaped battery inside the key fob will last between two and four years, based on the frequency with which it is utilized, the place it was purchased, and the way it is utilized. The date of use is usually printed on the packaging or in the manual.

If the key fob is no longer working after exposure to pure tapwater, you need to remove the battery and clean the electronic chip with the help of a paper towel that has been soaked with isopropyl ethanol. Then dry the chip thoroughly before replacing. In the event of exposure to salty or soapy water, the chip could be fried and you will need to replace the key fob in total.

If you're not sure whether the battery is in good condition You can test its voltage with an instrument connected to the plus and minus terminals. If the voltage is less than 12-13 volts you should replace the battery. If you want to, you can try to reset your on-board computer by disconnecting the battery with 12 volts for a few minutes, and reconnecting it in reverse order (positive cable first and then negative). The engine should start after this.

Faulty Receiver Module

If you're not getting the "Key Detected" message on your dashboard, then it's possible that your receiver module has been afflicted with a fault. It's the part that sends a signal to the car when your key fob is activated, that also acts as an immobiliser, and stops it from starting unless the correct key is used.

This could be due to a variety of factors including water damage or simply aging. If the chip inside your Peugeot 308 keyfob is damaged by dirty tap water it could be due to the fact that the keyfob was contaminated with it. In this instance, you'll need to take it out and thoroughly clean it with isopropyl or electronic cleaner. When the battery is clean you can attempt to test it again.

If the issue continues to persist, it's probably a good idea to visit a local Peugeot specialist or locksmith. They can use an instrument for diagnosing to identify the issue and then fix it.

The loss of your Peugeot keys to your car is an incredibly stressful experience. However, a reputable auto locksmith can fix the issue in just a few minutes. They can program your car and cut a fresh, working key for you. Click here to find a locksmith near you.

Faulty Electronic Chip

The electronic chip inside the Peugeot 308 key fob is an important part of the remote control system. If the chip is damaged, you could experience difficulties starting your vehicle or get a message saying "anti-theft". In this situation, the only solution is to replace the key. Auto locksmiths with experience are able to provide the service in the shortest time.

The chip in your peugeot key replacement 308 key fob can be damaged due to water damage, sweat dirt, or other causes. If your Peugeot 308 key fob is exposed to soapy water, you should clean it right away. You can wipe the electronic component using the help of a towel that is soaked in isopropyl Alcohol. The battery must then be allowed to completely dry.

Sometimes, a key fob can stop working because of radio interference. This could be caused by other devices that operate on the same frequency as your Peugeot key fob. This can be caused by poor conditions or objects within the vicinity of the vehicle. If you encounter this issue, it is best to visit a Peugeot dealership.

The Peugeot key fob 207/308 is extremely delicate and requires extra attention. It is essential not to drop or throw the key fob. If you lose something, try to locate it as soon as you can. You can reset all the on-board computers by disconnecting the battery that is 12 volts for a short period of time. Make sure you disconnect the negative cable first, and then the positive.