Seat Alhambra Key Problems

Seat's jumbo MPV range is among the top in its class when it comes down to resales value. With a new model on sale, the jumbo family MPV is even more impressive.

There are many reasons the key fob won't work properly, including a dead coin battery, damage to the receiver module, or signal interference. This article will walk you through the steps to get it working again.

Water Damage

If your seat alhambra keyfob is able to survive an wash cycle or bath in the pool or ocean then it is likely to have an amazing waterproof chip. However, be careful not to make this a routine because exposure to water in excess increases the risk of the key fob becoming damaged. If the key fob ceases to functioning after exposure to clean water from the tap or rain then simply remove the battery, clean the electronic component with paper towel and let it dry completely before putting the battery back in. If you are exposed to soapy or salty water it is recommended to wash the chip with alcohol, isopropyl or electronic cleaner prior Seat Keys Replacement to attempting to insert the battery back in.

Faulty Receiver Module

If you have tried a new button cell battery and the key fob still isn't locked or unlocking, it's likely the receiver module has found a fault. It's a fairly simple and affordable fix. You can unplug the 12 volt battery for a couple of minutes (first remove the negative cable and then press the horn numerous times) in order to drain any remaining power. Then connect it in reverse. Positive cable first, then negative.

ESP Warning Light If the ESP warning light flashes, this is normal and means that the car is travelling on terrain in which the traction between the road surface and tyres isn't optimal, like snow, gravel or lots of surface water. If the ESP light is always on, it means that there is a flaw in the system. It can be detected by using an iCarsoft i908 seat car key OBD code reader kit. It will provide you with a a detailed fault description.

Dead Coin Battery

One of the most common reasons for the seat alhambra key to stop working is a dead coin battery. The key fob contains an insignificant button cell battery that keeps it running. It is recommended to replace it by a new battery with exactly the same size, voltage and specifications as the original. When replacing the battery on the key fob, remove all metal clips and ensure that the contacts of the key fob are clean and corrosion-free.

If the key fob was exposed to water (such as soapy tap water) it is recommended to remove and clean the chip with an electronic cleaner or isopropyl alcohol before installing a new battery. The chip is sensitive to moisture and may be permanently damaged. If the key fob doesn't work after replacing the battery, it might be necessary to replace the key fob.

Faulty Receiver Module

If your key fob stopped working after you replaced the battery and it did not help, or it stopped working completely without notice The receiver module might have developed a fault. The receiver module is responsible for absorbing the radio frequency signals transmitted by your remote key fob and converting them into electrical commands that are then acted on by other modules in your car.

If the receiver module is damaged it will not take any commands from your remote key fob. In this scenario, you will need to visit a dealer for reprogramming of your key fob and a new receiver module.

The key fob features rubber seals that prevent water from getting into the electronic chip inside. If you immerse the key fob in salted or soapy ocean water, the chip inside could be damaged. If your key fob doesn't work, try cleaning the chip using isopropyl or electronic cleaner.

If the keys are paired but the receiver module has developed a fault you may try to restart all of the onboard electronics by disconnecting the battery that is 12 volts for a few minutes. Then, reconnect the battery in reverse order (negative cable first and then positive). This will reset all electronic components onboard and bring them back into operation.

Electronic Chip Faulty

The key fob is fitted with a chip that transmits a signal from the key to the receiver module each time the key is used. If the signal doesn't match the one that the car has stored, the immobilizer will disable and stop the car from starting. If, however, the key fob is not working and you are unable to reprogram it then it could be due a damaged chip.

The chip inside the key fob may need change in order to get it working again. This can be done by taking the key fob away from its case, and using pins or needles to touch each metal clip. If the clips are corroded, or broken, you will have to replace them to allow the remote control to function. Make sure the replacement batteries are of the same size, voltage and specifications as the original.

Seat keys Replacement Alhambra is a well-known and well-designed model, Seat Keys replacement can have issues with certain components or equipment. For example there are owners who have had issues with the automatic climate control system, which could malfunction and cause problems in one specific setting. Similarly, the infotainment system has also been recognized to malfunction and even freeze screens.