Wood Burning Stoves Near Me

Wood stoves are a carbon-free renewable heat source that can save money on energy bills. They also aid in active woodland management, which is beneficial to wildlife.

However, if they aren't installed and maintained properly they can produce carbon monoxide which can pose health risks to the family. To avoid this, look for an EPA-certified wood stove equipped with modern technology to ensure safety.

Catalytic Stoves

A catalytic fireplace is equipped with a special catalyst, which resembles honeycomb. It converts wood smoke into water and carbon dioxide. This is a fantastic option for anyone looking to reduce indoor air pollution while saving money. These stoves use less 5kw multi fuel stove, burn hotter, and produce less creosote. However, they can be more expensive to operate than non-catalytic models and require regular maintenance of the combustion chamber.

Wood Stoves that are EPA-Certified

The EPA requires wood stoves to be constructed in accordance with certain guidelines that limit their emissions. These guidelines dictate that a catalytic wood stove must be tested at a level that is not more than 7.5 grams of smoke per hour. This is in comparison to 4.1 grams of smoke per hour for a non catalytic stove. It's important to remember that lower emissions ratings do not necessarily translate into better efficiency in heating.

Sizing and Selection

It is very important to make sure your wood stove is appropriate for the house where it will be installed. The wrong size stove will not work as intended and may even overheat. A properly-sized stove increases heat output and reduces emissions. The brochure purchasing an EPA-certified Wood burning stove Stove (PDF 530K) offers a simple method of sizing and selecting the right wood stove.

Non-Catalytic and Catalytic stoves

The first wood stove that was made was a non-catalytic multifuel stove. They are also referred to as traditional wood-burning stoves or open fire stoves. The non-catalytic stove has the advantage that it doesn't need a second combustion to reduce emissions. Smoke is the primary source of energy waste. The smoke produced by non-catalytic stoves has a poisonous substance called creosote. The introduction of the catalytic wood stove has eliminated these problems. The catalytic stove uses a catalyst that burns the gases in the smoke to eliminate the toxic creosote.

The catalytic wood burner was developed to lower the emission of toxic gases. However it's less efficient than the secondary combustion system used in the non-catalytic model. The catalyst is unable to completely burn the byproducts from burning wood and therefore still emits harmful emissions. Additionally the honeycomb structure the catalyst could degrade over time. This can lead to a decrease in performance and the need for replacement.

Maintaining the Combustion Chamber Clean

A functioning catalytic combustor will have an appearance of light gray powdery. It must be free of soot, ash or other materials which could block the cells and decrease the catalytic surface. The combustor shouldn't be subjected to flame impingement. This can occur when a powerful, fast draft pulls flames directly into a catalytic converter. This can also happen when you open the firebox or the doors to the ash pan open.

It is essential to regularly inspect the catalytic combustor to determine whether it has physical damage and a need to be replaced. If it is damaged or requires replacement, it must be done as soon as possible to ensure maximum performance.