Fiat 500 Key Fob Replacement

If your 500 keyfob ceases working, try a different one to determine if it will be detected by the car. If it does, then the issue may be with the battery or water damage on the fob that was originally used.

First replace the battery. Make sure that the new coin battery is properly inserted, with the "+" side facing down on the fob.

Dead Battery

The battery is often the reason behind the fob not functioning. It's not difficult to fix Most fobs provide a warning signal if the battery is not fully charged. You can find the correct procedure on YouTube for nearly every key fob in your car or in the owner's manual. You can also replace it by taking it to an expert locksmith or the dealer who supplied it to you.

Other times a fob can stop working and there may be a problem with the circuit board in the internal circuit. This is a bit rare however it can happen. The internal chip can be damaged in the event that you drop the fob on something that is hard. This is also the case if you use an aftermarket key and the fob does not work. In this situation, you will be required to go to an authorized locksmith or dealer and have it reprogrammed to work with your 500.

One 2012 FIAT 500 Flip Key Remote - resembles Ilco brand with lock, unlock and trunk buttons. This is a new keyless entry remote (will need to be cut & programmed by a locksmith)

Damaged Chip

A key fob with the fiat 500 number is an wireless device that sends the signal needed for the car to start after you press the button. It is equipped with a microchip that contains the information which is required to communicate with the car. If the chip is damaged it won't transmit the correct code and the car will not start. It's possible to repair this kind of damage and a locksmith will help. United Locksmith can complete this repair on both classic and modern models, so don't hesitate to contact us.

Locksmiths can program a new key fob. It is cheaper to do this than going to the dealer and works the same way. You'll need to provide certain information to the locksmith, such as the year that your car was made and the model.

If you are not sure how to fix this problem you can try rubbing the chip with an US dollar bill. The copper on the bill is abrasive enough to remove oxidation and dirt, but it will not cause any harm to the microchip. If the chip is physically damaged, it might not be capable of being repaired. This could happen if you lose it, drive it over with your vehicle or other form of physical stress.

Water Damage

If you've accidentally dropped your keys in the pool, left them in your purse while swimming at the beach, or splashed them with water during a rainy day, it's likely that your key fob is likely to suffer water damage. Even if it only has a small amount of water on its key, it could cause serious issues with its electronics and prevent it from working effectively.

You can usually fix this issue by taking the fob off and cleaning it with a towel. Once the fob has dried, you can then replace the battery and it will start working again.

You can take it to an auto shop or locksmith to have it professionally programmed and cleaned. They can employ special equipment to ensure that the fob's key works with your car's computer.

If your fiat panda key fob replacement 500's main fob ceases to work, it could be frustrating and stressful. You might be tempted to visit a dealer to have your key fob replaced but this could be costly and inconvenient. Locksmiths can take care of every aspect of your car's key fob replacement without the necessity of a dealer visit. They are a better option than a dealer, as they can handle every aspect of the replacement of your car's key fob without the need for a dealership visit.

Pairing Issues

If you lose your key fob or it ceases to function and there is nothing the issue this could be because of the chip that has gone off the rails. This could be due to water damage or a dead battery.

It is usually done by simply following the instructions in the owner's manual. However, it's a good idea to have a locksmith from your automotive perform this procedure if you're having trouble or the instructions in your manual don't work for you. This will ensure that the chip is not damaged, and is the most economical option.

Another issue that plagues some 500 owners is that the key fob will not secure the car. This can be a problem when you plan to fill up at a gas station. Some owners have reported that the locking system of their 500 been damaged and they have needed to replace the entire intermediate steering shaft. This issue was described in a technical support bulletin (TSB) by Fiat.

A reputable locksmith can assist you in the event that your Fiat is having problems. They can duplicate your current key or create a new one that is able to lock and start the car. They can do this without seeing your old key, and it's usually cheaper than purchasing one from the dealer.