Ghost 2 Immobiliser Problems

The Ghost 2 immobiliser, designed to guard cars against key cloning or hacking is a discrete device that can be put in place without causing any damage to your vehicle. It will not allow you to start your car unless you enter the correct sequence of keys in your vehicle. This is similar to the mobile password.

Stop/Start

Ghost Immobilisers prevent vehicles from being stolen by preventing the engine from starting until it is issued the correct PIN code. This is done without modifying the vehicle, and is not detected by thieves. The unit communicates with the ECU on the CAN data bus to immobilise the vehicle. This system is similar to that used by car manufacturers for many years. However, thieves are unable to overcome it using a brand new key or key relay technology, as they can using factory-installed systems.

Ghost is compatible with all vehicles with an engine, which includes cars, vans, motorhomes, caravans, and bikes. The same system is compatible with electric cars. It's a great alternative to wheel clamps and steering wheel locks.

When the Ghost is activated, it will block all buttons in your vehicle and prevent the ignition from being started without a PIN code having been entered first. You can enter the code manually or via the Android or Apple app. If a wrong code is entered, the app will display an indicator light and the Ghost will not allow the vehicle to be started again. This is a great way to discourage thieves. If the vehicle is unable to be started, they will move on.

The Ghost is small, weatherproof device that can be hidden in the most difficult to access areas of your vehicle. Installation takes between 20-30 minutes for each vehicle. It is also simple to remove if you decide to change vehicles, or to give it to the valet or service center parking. It is an TASSA (Tracking and Aftermarket Security Systems Association) an insurance-approved system, and is recognized by certain insurance companies. It also comes with an emergency lock that is secure Pin Code Override, and a Service/Valet mode which can be activated by pressing a button on the app or using your key fob.

Disarm

Ghost immobilisers are not mechanical devices to prevent theft that can be removed, are hidden inside the vehicle. Even if they were discovered, thieves would not be able to start the car. They are virtually impossible to bypass or hack. This is because a ghost immobiliser blocks key cloning, signal jamming and device spoofing, all of which are methods that are frequently used by thieves to gain access to vehicles with standard immobilisers.

The immobiliser sends a message to the ECU. If the wrong code has been received and the vehicle doesn't start as the engine won't start. While it is possible to disable the ghost immobiliser by using a software tool this would be very time-consuming and difficult. Only an authorised installer can install and use the software.

The Ghost immobiliser is a tiny device that is part of the vehicles wiring loom and is not visible to the naked eye once installed. It is not visible on diagnostic systems. There are no LED indicators and it doesn't communicate with the engine through the OBD port. It communicates silently via the CAN data circuit.

The system will not allow the vehicle to start until it is given an input PIN number that is specified by the user. This is entered through buttons on the steering wheel and door panels as well as the central console. This is a safer way to safeguard your car since it doesn't require the use of keys or remote control.

Ghost also has a service mode that can be turned on via the mobile application. This allows you to hand over your keys to a person for service or valet parking without entering the disarm sequence.

If your Ghost is in service mode or not you should never attempt to remove the system on your own since it could impact your engine and cause damage. It is recommended to speak with a TASSA verified installer who can remove the system safely and properly. Our newest ghost 11 immobiliser II immobilisers also include the QR fingerprint stickers that is hidden in various locations of your vehicle. these are linked to our international security register - in the event that the system is removed and sold on the black market it will be linked back to its original owner.

Anti-Hijack

Ghost Immobiliser 2 has a highly effective anti-hijack function. It functions like smart keys and is among the most secure ways to protect your vehicle from thieves. If the ignition switch is turned to on, and the vehicle is stationary for 30 seconds then the Ghost system will automatically stall the engine and switch the hazards lights on. This gives the driver and passengers time to press the security button before the system can be activated.

In contrast to other systems that simply stall the engine when the ignition is switched on and on, the Ghost system is based on a specific controller and timer that will shut off the fuel cut-off valve 14 if it is activated after an agreed-upon time even in the event that the ignition is switched on! The delay time should be long enough to allow the hijacked vehicle owner to get away, and a distance sufficient from the car that it is stuck before the system is reactivated.

In addition to the standard CANbus immobiliser blocking capabilities of the Ghost system, it comes with an additional level of security that prevents common hacking methods used to gain access to modern cars such as relay attacks key range extending, key range hacking and ECU swapping. The Ghost system communicates in a quiet way and does not emit signals that can be detected by thieves with RF scanning or code-grabbing technology.

The Ghost system also has the Service/Valet mode that allows your vehicle to be temporarily started and driven without the requirement of a PIN code. This is perfect if you are parking your car and need to be away for a short period of time, for instance, to put your groceries in the boot or open a garage door. The system will exit service mode depending on the speed and time or through the simple PIN code input process and give you assurance that only YOU can utilize your vehicle!

Keyless Entry

Many customers are now looking for extra security measures due to the rising trend of thefts from cars using contactless. This is especially relevant for those who have invested time and money to customise their vehicles or own expensive cars. An add-on immobiliser can be an affordable method to stop this type of theft as it can prevent your vehicle from starting until the right pin code is entered on your key fob.

Immobilisers are designed for various vehicle circuits, including those that control starter motors as well as fuel pumps. They can also turn off the alarm for cars in order to draw attention and ward off potential thieves.

These devices communicate with the engine control unit (ECU) through the CAN data circuit. They also they stop the thief trying to bypass it by putting in a new ECU or by using the key programmer. These immobilisers can be fitted discreetly in your vehicle, leaving no trace and are completely inaccessible to the tools sophisticated thieves use.

The Ghost immobiliser differs from other systems that require the driver to wear tags or an app. Instead, you are able to select your personal pin sequence by pressing the pattern on your steering wheel, door panel, and the centre console. The pin can be easily changed, making the device as secure as a bank card. It can also be more difficult to crack since it requires as many as 20 presses.

Ghost also has a Valet/Service mode, which permits users to deactivate it when you plan to give your vehicle to valet parking or service. This allows the system to function within certain parameters, such as a 30-mph speed limit. It can then be reactivated with the original key or corresponding entry code.

Installed by our reputable installers and certified installers, it is the most secure and efficient aftermarket CAN-immobiliser on the market. It is also fully certified by Thatcham for insurance purposes. The Ghost 2 immobiliser comes with six QR fingerprint labels and an ISR contact cards containing your unique QR codes along with an emergency code that is safe. They are all stored in your purse or wallet.