Ghost 2 Immobiliser Problems

The Ghost 2 immobiliser, designed to protect cars from hacking or key cloning, is a discrete device that can be put in place without causing any damage to your vehicle. It stops your vehicle from starting unless you press a specific sequence of buttons within your vehicle, similar to a password on mobile phones.

Stop/Start

Ghost Immobilisers protect vehicles from being stolen by preventing the engine from starting unless it receives the correct PIN code. This is done without modifying the vehicle, and is undetectable by thieves. The unit is directly connected to the ECU via the CAN databus to lock a vehicle. This is the same system the one used by car makers for many years. However, thieves cannot escape it using a new key or key relay technology, as they can do with factory-installed systems.

A Ghost can be fitted to any car, van, motorhome, caravan or bicycle that has an engine. It is compatible with all major brands of vehicles. The same system can be utilized on electric vehicles. It is an excellent alternative to steering wheel locks and wheel clamps that can be installed with minimal effort.

If the Ghost is activated it will stop all buttons in your car and prevent the ignition being started without a PIN number. You can enter the code manually or via the Android or Apple app. If the wrong code is entered, the app will show an indicator light and the Ghost will not allow the vehicle to start again. This is a great deterrent. if the vehicle can't be started the thief will continue to pursue a new area of.

The Ghost is a weatherproof, small device that can be hidden away in the most inaccessible areas of your vehicle. It is incredibly easy to install with an average of 20-30 minutes for each vehicle. It is also easy to remove should you choose to move your vehicle around or give it away to valet parking or service. It is an TASSA (Tracking and Aftermarket Security Systems Association), insurance approved system, which is recognized by some insurers. It also has a secure emergency Pin Code Override, and a Service/Valet mode that can be activated by pressing a button within the app or using your key fob.

Disarm

Ghost immobilisers, unlike mechanical devices to prevent theft that can be removed, are hidden in the car. Even if they were to be found, thieves would not be able to start the car. They are almost impossible to hack or bypass. A ghost immobiliser is protected from key cloning, as well as devices spoofing signals and signal jamming. These are the methods thieves use to gain access into cars that have standard immobilisers.

The immobiliser sends a message to the ECU. If the wrong code is received and the vehicle is not started because the engine will not start up. While it is possible to disable the ghost immobiliser using a software tool it is lengthy and complicated. Only an authorised installer can install and use the software.

The Ghost immobiliser is a tiny device that is tucked away in the wiring loom of the vehicle and is inaccessible how to fit a ghost immobiliser the naked eye once installed. It is not visible on diagnostic systems. There are no indicators with LEDs, and it isn't able to communicate with the engine through the OBD port. It communicates silently through the CAN data loop.

The system won't allow the vehicle to start until it receives an input PIN code that is entered by the user. This is entered through buttons on the steering wheel, door panels or centre console. This is a safer way to protect the car, since it doesn't require an additional remote control or key fob.

In addition to this Ghost offers a service mode which can be activated by using the application on your mobile phone. This lets you give your keys to someone else for service or valet parking, without needing to enter a disarm sequence.

It is not recommended to remove the system on your Ghost by yourself, regardless of whether it's in service mode. This can damage your engine. It is recommended to contact an TASSA-certified installer who can safely and properly remove the system. Our newest GHOST II immobilisers come with an exclusive QR fingerprint sticker that is hidden in various areas of your vehicle, they are linked to our global security register - in the event that the system is removed and then sold on the black market this will connect it back to the original owner.

Anti-Hijack

The anti-hijack feature is a very important feature of the Ghost Immobiliser 2. This system works like smart keys and is among the most secure methods to ensure your car is safe from thieves. The Ghost system will automatically turn on the hazard light and stop the car's engine when the ignition is turned on and the vehicle is in a stationary position. This gives the driver or passengers enough time to press a security button (depending on the vehicle) before the system reactivates and the engine is again allowed to start.

In contrast to other systems that simply stall the engine when the ignition is switched to on The Ghost system is based on a specific controller and timer that will shut off the fuel cut-off valve 14 in the event that it is activated within a set period of time even if the ignition is still in operation! The delay time must be sufficient to allow the person who was hijacked to drive away and be a sufficient distance from the vehicle that is stalled before the system is activated.

In addition to the standard CANbus immobiliser blocking features of the Ghost, it has an extra security level that blocks common methods of hacking used to gain access to modern cars such as relay attacks key range extending, key range hacking and ECU swapping. This is because the Ghost system is completely silent and does not emit any signals that can be detected by a criminal using RF scanning or code grabbing technology.

The Ghost system also has the option of a Service/Valet mode that allows your vehicle to be temporarily re-started and driven without the requirement of PIN codes. This is a great option if you park your car and only need to leave it for a brief time, such as to open the garage door or place groceries in the boot. The system will end the service mode according to speed and time or through an easy PIN code input process. This will give you complete peace-of-mind that only YOU can drive your car!

Keyless Entry

Many customers are seeking additional security measures due to the increasing trend of car thefts using contactless technology. This is particularly relevant for those who have invested time and money in customizing their car or own expensive cars. Add-on immobilisers can be a good way to prevent this kind of theft as they can prevent your vehicle from starting until the correct pin code is entered, along with your key fob.

Immobilisers are designed to intercept various vehicle circuits, including those that control the starter motor and the fuel pump. They can also shut off the alarm for cars in order to attract attention and deter potential thieves.

These devices communicate directly with the engine control unit using the CAN data network. They stop the thief from gaining access to it by installing a replacement ECU or by using key programmers. The immobilisers can be installed discretely inside your vehicle, leaving no trace and are completely undetectable by the tools that sophisticated thieves use.

In contrast to other systems that require a specific application, or a tag to be worn on the driver's person and a Ghost immobiliser can only be deactivated by pressing a pattern of the existing electronic buttons on your steering wheel, door panel and centre console, allowing you to choose a custom pin sequence. The pin can be changed as often as you want, which means it is as secure as a credit card, and can be more difficult to break because it requires up to 20 presses.

Ghost also has the Valet/Service mode, which lets you deactivate the system when your vehicle is going to be handed over to valet parking or service which allows it to work within certain guidelines, such as a 30mph speed limit, so you don't have to worry about your car being driven recklessly. The system can be reactivated using the original key or corresponding entry code.

Installed by our accredited installers, it is the most secure and reliable aftermarket CAN-immobiliser that is available. It is also certified by Thatcham for insurance purposes. The Ghost 2 immobiliser is also equipped with six QR fingerprint labels and an ISR contact card containing your unique QR code as well as a secure emergency code that are kept in your purse or wallet of your vehicle.