Ghost 2 Immobiliser Problems

Designed to protect vehicles from hacking and key cloning, to protect them from key cloning and hacking, the Ghost 2 immobiliser is a discreet device that can be fitted without damaging your car. It stops your vehicle from starting unless you enter a specific sequence of buttons inside your vehicle like the password you enter on the phone.

Stop/Start

Ghost immobilisers stop vehicles from being stolen by stopping the engine from starting until it is issued the correct PIN code. This is done without modifying the vehicle, and is undetectable by thieves. The unit communicates with the ECU via the CAN data bus to immobilise the vehicle. This is the same system the ones used by car manufacturers for many years. However, thieves are unable to bypass it with a new key or key relay technology, as they can using factory-installed systems.

Ghost is compatible with any vehicle that has an engine, including cars, vans, motorhomes and caravans, as well as bikes. The same system can be utilized on electric vehicles. It's a great alternative to steering wheel locks and wheel clamps that can be installed with little effort.

When the Ghost is activated it will block all buttons in your car and stop the ignition from starting without the PIN code. You can enter the code by hand or using the Android or Apple app. If a wrong code is entered, the app will display an indicator light and the Ghost will not allow the vehicle to start again. This is a great deterrent and if the vehicle can't be initiated, the criminal will then move on to a different target.

The Ghost is a small, weatherproof device that can be tucked behind the most difficult-to-access areas of your vehicle. Installation takes between 20-30 minutes for each vehicle. It is also easy to remove should you decide to switch your vehicle or give it away to valet parking or service. It is a fully TASSA (Tracking and Aftermarket Security Systems Association) insurance-approved system that is recognized by a number of insurance companies. It also comes with an emergency lock that is secure Pin Code Override, and a Service/Valet mode that can be activated by pressing a button in the app, or by using your key fob.

Disarm

Ghost immobilisers like mechanical anti-theft devices that are able to be removed, are concealed inside the vehicle. They are nearly impossible to hack or bypass and, even if they are discovered, a burglar will not be able to start the engine. This is because a ghost immobiliser blocks key blocking, signal jamming, and device spoofing, all of which are methods that are commonly used by thieves to gain entry into vehicles that have standard immobilisers.

An immobiliser functions by sending an instruction to the ECU (electronic control unit). If the incorrect code is received and the vehicle does not start as the engine won't start. Although it is possible to disable the ghost immobiliser by using software, this is very laborious and time-consuming. Only an authorised installer can install and use the software.

The Ghost immobiliser, which is a tiny device, is hidden in the wiring loom of the vehicle. It is not visible to the naked eye after it has been installed. It will not show up on diagnostic systems, it does not have LED indicators and it will not connect to the engine through the OBD port. It communicates in a silent manner via the CAN data circuit.

The system won't allow the vehicle to start until it receives an input PIN code defined by the user. This code can be entered using buttons on the steering wheels or door panels, or centre console. This is a safer way to safeguard your car as it does not require a key fob or remote control.

Ghost also has a service mode that is activated through the mobile application. This allows you to hand over your keys to a person for valet parking or servicing without having to enter the disarm sequence.

No matter if your Ghost is in service mode or not, you should not attempt to remove the system yourself as it can affect the engine and cause damage. It is recommended to speak with a TASSA-verified installer who can safely and effectively remove the system. Our newest GHOST immobilisers come with a unique fingerprint QR sticker, which is hidden in various parts of your vehicle. They are linked how to fit a Ghost immobiliser (aiga.oktomato.net) our security register. In the event that the system is removed and later sold on the blackmarket, this will allow you to trace the original owner.

Anti-Hijack

The anti-hijack function is an essential feature of the Ghost Immobiliser 2. This is a sophisticated key that shields your vehicle from thieves. Whenever the ignition switch is switched to on, and the vehicle remains stationary for a period of 30 seconds and the Ghost system will automatically stall the engine and turn the hazards lights on. This gives the driver and passengers enough time to press the security button before the system is reactivated.

In contrast to other systems that simply stop the engine when the ignition is switched to on The ghost immobiliser installer system has a unique controller and timer unit which will close the fuel cut-off valve 14 when it is activated after an agreed-upon time, even when the ignition is in operation! This delay period must be sufficient to allow the person who was hijacked to leave the vehicle and be a sufficient distance from the stalled car before the system is activated.

The Ghost has an additional layer of security to prevent common hacking techniques used to gain access to modern vehicles, such as relay attacks and key range expanding. This is due to the fact that the Ghost system communicates in a quiet manner and doesn't emit any signals that could be picked up by thieves using RF scanning or code grabbing technology.

The Ghost system comes with a service / valet mode which allows your vehicle to be temporarily started and driven without the need for PIN code. This is great when you park your car and need to be away for a short period of time, for instance, to put your items in the boot, open a garage door etc. The system will be able to exit service mode according to speed and duration or via the simple PIN code entry procedure and give you security knowing that only YOU can use your car!

Keyless Entry

With the rise of contactless car theft Many people are considering additional security options. This is especially relevant for those who have put in time or money in personalizing their vehicle or own expensive vehicles. Immobilisers that are added to your vehicle are a great way to deter this kind of theft, as they can prevent your vehicle from starting until the correct pin code is entered, along with your key fob.

Immobilisers are designed to be used on a variety vehicle circuits including those that control starter motors as well as fuel pumps. They can also turn off the alarm for cars in order to draw attention and scare away potential thieves.

These devices are directly connected to the engine control unit via the CAN data network. They prevent the thief from bypassing it by installing a replacement ECU or using key programmers. These immobilisers are installed discretely and do not leave any marks in your vehicle. They are also not detected by sophisticated tools used by thieves.

In contrast to other systems that require a particular application, or a tag to be worn on the driver's person, a Ghost immobiliser can only be disarmed by pressing a series of existing electronic buttons on your steering wheel, door panel and central console, allowing you to choose a custom pin sequence. The pin can be easily changed to make the device as secure as a credit card. It's also more difficult to hack since it requires as many as 20 presses.

Ghost also has a Valet/Service mode, which permits you to disable it if you intend to surrender your vehicle for valet parking, or for service. This allows the system to operate within the parameters such as a 30 mph speed limit. The system can be activated using the original key or entry code.

Installed by our certified installers and certified installers, it is the most secure and reliable aftermarket CAN-immobiliser that is available. It is also fully approved by Thatcham for insurance purposes. The Ghost 2 immobiliser is also equipped with six QR fingerprint labels and an ISR contact card containing your unique QR code as well as a secure emergency code, all of which you keep in the wallet/purse of your vehicle.