Ghost 2 Immobiliser Problems

It is designed to safeguard vehicles from hacking and key cloning, The Ghost 2 immobiliser is a discrete device that is able to be fitted without damaging your car. It will not allow you to start your vehicle unless you press the correct sequence of buttons in your vehicle. This is similar to the mobile password.

Stop/Start

Ghost immobilisers protect vehicles from being stolen by preventing the engine from starting until it is issued the correct PIN code. This is accomplished without altering the vehicle, and is not detected by thieves. The unit is directly connected to the ECU through the CAN databus to lock a vehicle. This is the same system the ones used by car manufacturers for many years. However, thieves cannot escape it using a new key, or key relay technology, like they could with factory-installed systems.

Ghost Ghost can be fitted to any van, car, motorhome, caravan or bicycle that has an engine and is compatible with all popular makes of vehicles. The same system is compatible with electric vehicles. It is an excellent alternative to locking the steering wheel and wheel clamps, and can be installed with little effort.

If the Ghost is activated, it will block all buttons in your car and stop the ignition from starting without a PIN number. You can enter the code manually or via the Android or Apple app. If the incorrect code is entered the app will show an indicator light. The Ghost will not let the vehicle be started again. This is a great method to deter thieves. If the vehicle is unable to be started and they are unable to get it started, they will leave.

The Ghost is a weatherproof small device that can be tucked away in the most difficult to access areas of your vehicle. Installation takes between 20-30 minutes for each vehicle. It is also easy to remove should you decide to switch your vehicle or hand it in for service or valet parking. It is an TASSA (Tracking and Aftermarket Security Systems Association) an insurance-approved system, which is recognized by certain insurance companies. It also comes with an emergency Pin Code override and features a Service/Valet Mode that can be activated with the application's button or using your key fob.

Disarm

Ghost immobilisers are not mechanical devices to prevent theft that can be removed, are concealed in the car. Even if they were to be found, thieves would not be able to start the car. They are almost impossible to hack or bypass. This is because a ghost immobiliser blocks key hacking, signal jamming and device spoofing - techniques that are frequently used by thieves to gain access to vehicles that have standard immobilisers.

The immobiliser sends a code to the ECU. If a wrong code has been received and the vehicle does not start because the engine will not fire up. It is possible to disable a ghost immobiliser by using a software tool, but it would be extremely time-consuming and difficult to do so. The software must be installed and used by a authorised installer.

The Ghost immobiliser is a tiny system that sits within the wiring loom of your vehicle and is invisible to the naked eye after it has been installed. It is not visible on diagnostic systems, there aren't LED indicators and it does not connect to the engine via the OBD port. It communicates without sound through the CAN data circuit.

The system will block the vehicle from starting unless it receives a user defined PIN code sequence. This code can be entered using buttons on the steering wheel and door panels as well as the centre console. This is a safer way to safeguard your car since it doesn't require an additional remote control or key fob.

Ghost also has a service-mode that can be activated via the mobile application. This allows you to give your keys to someone else for valet parking or service without needing to enter a disarm sequence.

Whether your Ghost is in service mode or not, you should never attempt to remove the system yourself as it can affect your engine and cause damage. It is recommended to contact a TASSA-verified installer who can safely and effectively remove the system. Our latest GHOST II immobilisers also come with a special QR fingerprint sticker that is hidden in various areas of your vehicle, these are linked to our global security register. In the event that the system is removed and sold on the black market it will be linked back to its original owner.

Anti-Hijack

Ghost Immobiliser 2 has a very useful anti-hijack feature. This system functions as an intelligent key and is one of the most secure methods to protect your vehicle from thieves. The Ghost system will automatically switch on the hazard lights and stall the car's engine when the ignition is turned on and the vehicle is stationary. This allows the driver or passengers enough time to press a security button (depending on the vehicle) before the system reactivates and the engine is once again allowed to begin.

The Ghost system, unlike most competitors, uses a timer and controller unit that will close the fuel shut-off valve 14 after a predetermined time. This happens even if the ignition remains on. The delay period must be sufficient to allow the hijacked vehicle owner to get away, and a distance sufficient from the car that it is stuck before the system is reactivated.

In addition to the standard CANbus immobiliser blocking features of the Ghost, it has an additional security level that blocks common methods of hacking employed to gain access to modern vehicles like relay attacks, key range extending and ECU swapping. The Ghost system communicates in a silent way and does not emit signals that could be snatched by thieves with code-grabbing technology or RF scanning.

The ghost immobiliser fitter system has an option for service or valet mode that allows your vehicle to be temporarily started and driven, without the need for a PIN code. This is a great option if you park your car and only require it to be left for a short time, such as to open the garage door or put groceries in the boot. The system will be able to exit service mode based on speed and time or through the simple PIN code entry procedure that gives you total assurance that only you can use your vehicle!

Keyless Entry

With the rise of car thefts that are not involving contact, many customers are looking into extra security options. This is especially relevant for those who have put in time or money into personalising their vehicles and own expensive or rare vehicles. Immobilisers that are added to your vehicle are a great way to deter this type of theft because they will stop your vehicle from starting until the correct pin code is entered along with your key fob.

Immobilisers are designed to intercept a variety of vehicle circuits which include those that control the starter motor and the fuel pump. They can also turn off the car alarm in order to draw attention and ward off potential thieves.

These devices communicate with the engine control unit (ECU) via the CAN data circuit. They also they stop the thief trying to get around it by putting in a new ECU or by using the key programmer. The immobilisers are fitted discreetly and leave no marks in your vehicle. They are also not detected by sophisticated tools used by thieves.

As opposed to other systems that require a particular application, or a tag to be worn on the driver's person, a Ghost immobiliser is only disarmed by pressing a pattern of existing electronic buttons on your steering wheel, door panel, and centre console, allowing you to select a customized pin sequence. The pin can be changed as frequently as you'd like, meaning the device is as secure as a credit card, and can be even more difficult to hack because it requires up to 20 presses.

Ghost also comes with a Valet/Service mode, which allows you to deactivate it if you plan to give your vehicle to valet parking, or service. This allows the system to operate within parameters, such as a 30-mph speed limit. It can then be reactivated with the original key or appropriate entry code.

This makes it the most efficient and secure aftermarket CAN-based immobiliser on the market. It is insurance approved by Thatcham as an accessory to your vehicle when installed by one of our accredited installers. The Ghost 2 immobiliser comes with six QR fingerprint labels, as well as an ISR contact card with your unique QR codes as well as a secure emergency code. These are all kept in your purse or wallet.