Ghost 2 Immobiliser Problems

Designed to protect vehicles from hacking and key cloning, The Ghost 2 immobiliser is a discrete device that can be installed without damaging your vehicle. It stops your car from starting until you press a specific sequence of buttons inside your vehicle, similar to a password on a mobile phone.

Stop/Start

Ghost immobilisers protect vehicles from being stolen by preventing the engine from starting until it is issued the correct PIN code. This is done without modifications to the vehicle and is completely undetectable to thieves. The unit communicates directly with the ECU via the CAN databus to lock the vehicle. This is similar to that used by car manufacturers for many years. However, thieves cannot bypass it with a new key or key relay technology, like they can do with factory-installed systems.

Ghost Ghost can be fitted to any car, van motorhome, caravan, or bicycle with an engine. It's compatible with all popular makes of vehicles. The same system is compatible with electric vehicles. It's a great alternative to steering wheel locks and wheel clamps, and can be installed with little effort.

When the Ghost is activated it will stop all buttons in your car and prevent the ignition being started without the PIN code. You can enter the code manually or through the Android or Apple app. If the incorrect code is entered, the app will display an indicator light. The Ghost will then refuse to let the vehicle to be restarted. This is a great deterrent, and in the event that the vehicle cannot be started the thief will then move on to a different target.

The Ghost is small, weatherproof device that can be hidden in the most difficult to reach areas of your vehicle. The installation process takes between 20 and 30 minutes for each vehicle. It is also simple to remove if you decide to change vehicles, or even give it to a service center or valet parking. It is a TASSA (Tracking and Aftermarket Security Systems Association) an insurance-approved system that is recognized by certain insurance companies. It also comes with an emergency security feature that is secured by Pin Code Override, and a Service/Valet mode which can be activated by pressing a button on the app or by using your key fob.

Disarm

Ghost immobilisers are not mechanical devices to prevent theft that can be removed, are concealed in the car. They are near impossible to bypass or hack and, even if they are discovered, thieves cannot start the engine. This is because a ghost immobiliser prevents key cloning, signal jamming and device spoofing - techniques that are commonly used by thieves to gain entry into vehicles with standard immobilisers.

The immobiliser sends a code to the ECU. If a wrong code is sent the vehicle will not be started as the engine will not start up. It is possible to disable a ghost immobiliser with a software tool, but it is very difficult and time consuming to accomplish this. Only an authorized installer is able to install and use the software.

The Ghost immobiliser, which is a tiny device, is hidden within the wiring loom of your vehicle. It is invisible to the naked eyes once installed. It does not appear on diagnostic systems. There are no LED indicators, and it doesn't communicate with the engine via the OBD port. It communicates without sound via the CAN data circuit.

The system won't allow the vehicle to start until it is given an input PIN number that is specified by the user. The PIN code is entered via buttons on the steering wheel or door panels, or on the centre console. This is a safer way to protect the car, since it doesn't require the use of a remote or key fob.

In addition to this Ghost offers an option for service that can be activated through the application on your mobile phone. This will allow you to give your keys to someone else for service or valet parking without entering the disarm sequence.

No matter if your Ghost is in service mode or not, you should never attempt to remove the system by yourself because it could affect your engine and cause damage. It is recommended to speak with an TASSA certified installer who can remove the system in a safe and secure manner. Our newest GHOST II immobilisers also include a special QR fingerprint sticker that is hidden in different locations of your vehicle. these are linked to our global security register. In the event that the system is removed and then sold on the black market this will link it back to its original owner.

Anti-Hijack

The anti-hijack feature is an essential feature of the Ghost Immobiliser 2. This system works like an intelligent key and is one of the most secure ways to keep your car safe from thieves. When the ignition switch is switched to on, and the car remains stationary for a period of 30 seconds, the ghost 2 immobiliser review system will automatically stop the engine and turn the hazards lights on. This gives the driver and passengers time to press the security button before the system is activated.

Contrary to many other systems that simply stall the engine once the ignition switch is turned on and on, the Ghost system uses a special controller and timer that will close the valve for cutting off fuel 14 in the event that it is activated within a set period of time even if the ignition is still in operation! The delay time frame needs to be long enough to allow the victim of the vehicle to drive away from the site of the incident and to maintain a sufficient distance from the vehicle in which it is stuck before the system is able to reactivate.

The Ghost has added security to prevent common hacking techniques used to gain access into modern cars, such as relay attacks and key range expanding. This is because the Ghost system is completely silent and does not emit any signals that could be picked up by thieves using code grabbing or RF scanning technology.

The Ghost system has an option for service or valet mode which allows your vehicle to be temporarily started and driven, without the need for a PIN code. This is ideal if you park your car and only need to leave it for a brief time, such as to open the garage door or place groceries in the boot. The system will exit the service mode according to the speed and time, or via an easy PIN code input process. This gives you complete peace-of-mind that only YOU are able to drive your vehicle!

Keyless Entry

Many customers are now seeking out additional security measures due to the rising trend of thefts from cars using contactless. This is particularly applicable to those who have put in time and money into customising their vehicle or own rare/expensive automobiles. Immobilisers with add-ons can be an effective way to deter this kind of theft because they will stop your car from starting until the correct pin code is entered along with your key fob.

Immobilisers are designed for different vehicle circuits, including ones that control starter motors as well as fuel pumps. They also are able to shut down the car stolen with ghost immobiliser alarm to draw attention and scare off any potential thieves.

These devices connect directly to the engine control unit via the CAN data network and stop the thief from gaining access to it by installing a replacement ECU or using key programmers. These immobilisers can be fitted discretely inside your vehicle, leaving no trace and are totally invisible to the tools hi-tech thieves use.

In contrast to other systems that require a specific app, or a tag to be worn on the person of the driver, a Ghost immobiliser can only be disarmed by pressing a pattern of electronic buttons that are already present on your steering wheel, door panel and the centre console, which allows you to choose a personal pin sequence. The pin can easily be changed and makes the device as secure as a bank card. It's also more difficult to hack because it takes up to 20 presses.

Ghost also comes with a Valet/Service mode that allows you to disable the system when your vehicle is going to be handed over for valet parking or services, enabling it to operate within set guidelines, such as 30mph speed limits, so you don't have to worry about your vehicle being driven recklessly. It is then reactivated by using the original key or the key that corresponds to the entry code.

Installed by our accredited installers and certified installers, it is the most secure and reliable aftermarket CAN-immobiliser that is available. It is also fully accepted by Thatcham for insurance purposes. The Ghost 2 immobiliser is also supplied with six QR fingerprint labels as well as an ISR contact card that contains your unique QR code and a secure emergency code that you keep in the wallet/purse of your vehicle.