How to Replace a Nissan Juke Spare Key

Nissan Juke is a fun and stylish hatchback with an unusual engine setup. It's a bit noisy but still a blast to drive.

The key fob battery in your Nissan Juke should be replaced every two years or so, or if it's low. It is easy to do at home, but you'll need some tools.

Dead Coin Battery

If the key fob of your Nissan Juke has stopped working, check the battery for coins. It could be dead and needs to be replaced. This is a straightforward fix that takes just less than a minute. Flip the fob upside down and you'll be able access the tiny latch/release located at the back. Remove the battery that was in use and then put in the new one, ensuring sure it's facing downwards in the fob. Line between the two halves of the fob with care.

If the fob has been exposed to water, it needs to be cleaned before putting the new battery in. This can be done using a paper towel and isopropyl alcohol or electronic cleaner, and allow it to dry completely before re-inserting the battery.

The key fob also needs to be connected with the car to begin the engine, which can be done by following the instructions in the owners manual or an OBDII scanner. The most likely reason why the key fob was not working is because it wasn't properly paired. It is also possible that the fob is equipped with malfunctioning chips, but this is extremely rare. A new receiver module may be required in this scenario. If this is the situation it should be replaced by an expert technician.

Water Damage

The key fobs run on batteries, and the batteries should be replaced every two years or when the vehicle stops responding when you hit the "start" switch. The keys' rubber seals keep out water, but submerging a key fob in the pool or ocean can damage the chip's electronic. If this is the case, you will require a new key from Nissan or an automotive locksmith.

If the key's fob has functioning chips it's likely that the computer has simply lost connection to it. This can be the result of a variety of reasons. It can be fixed by restarting the car. If the "Key ID error" message continues to appear then you must contact Nissan for assistance.

The three most frequent reasons for this problem are dead battery on the key fob, a non-programmed key, and a damaged or defective key fob that is damaged or faulty. The first two issues can be fixed fairly easily while the third is more difficult to determine and repair but can be solved with patience. WhoCanFixMyCar lets you compare Nissan key Replacement (Heungil.net) prices in your region and schedule your repair. It only takes a few minutes and you can read reviews of customers from local garages, Nissan car mechanics and dealerships before deciding.

Faulty Chip

The key fob in your Nissan Juke has a special chip that sends an indication to the car whenever you turn it. The key may be inoperable when the chip is damaged. In this case you'll have to fix the problem by replacing the key. There are a myriad of reasons your Nissan Juke's key could be faulty, including water damage or a dead battery for your coin or a malfunctioning receiver module.

Examine the chip for water damage if your key fob has stopped working after a wash or bath. Make sure that the metal retainers are in good shape and that the chip is not exposed to water. If you observe any signs of water damage on the electronic component, take off the battery and wipe it down with isopropyl-ethanol or electronic cleaner.

If the chip is not working If the chip is defective, you must visit your local locksmith shop or dealership. They will need the year as well as the model, make and year of your vehicle to locate an alternative. You will also need to record the VIN (Vehicle Identification Number) to ensure that the locksmith or dealer can identify the key you have. This will enable them to locate the correct key code, and also ensure that they cut the correct key.

Faulty Receiver Module

The key fob sends a radio signal to your vehicle to perform various functions. The key fob can open your trunk when you are rushing with groceries to the car or start your car by pressing the fob's button. It can also open your windows and turn the horn on when you accidentally lock the keys inside your car.

If the key fob stops working, there may be an issue with the receiver module inside the vehicle. The receiver modules are tuned to ensure that they can pick up specific frequencies which correspond to the signals that are transmitted by Nissan key fobs. If your car is equipped with malfunctioning receiver modules and it stops responding to any signal sent by the key fob.

It's best to have a spare Nissan key fob in case the original key you have or breaks. A locksmith or a dealership can program a spare key that works with your Nissan. This will help you avoid the hassle of losing your keys or locking them in your car.

If your Nissan Juke key fob has been exposed to clean rain or tap water it is possible to have the issue resolved by cleaning it with isopropyl alcohol or electronic cleaner. If the chip has fried, you will need to purchase a new nissan key keyfob that can be programmed for your vehicle by a locksmith or dealer.