Ghost 2 Immobiliser Problems

Created to guard vehicles from hacking and key cloning, The Ghost 2 immobiliser is a discreet device that can be fitted without causing damage to your car. It stops your car from starting unless you press a specific sequence of buttons within your vehicle like the password you enter on mobile phones.

Stop/Start

Ghost immobilisers prevent vehicles from being stolen by preventing the engine from running until it is issued the correct PIN code. This is done without modification to the vehicle and is completely undetectable by thieves. The unit communicates directly with the ECU through the CAN databus to lock the vehicle. This is similar to that used by car manufacturers for years. However, thieves cannot bypass it with a new key or key relay technology, like they can do using factory-installed systems.

Ghost is compatible with any vehicle that has an engine, including motorhomes, vans, cars and caravans, as well as bikes. The same system can be utilized on electric vehicles. It's an excellent alternative to wheel clamps and steering wheel locks.

If the Ghost is activated it will block all buttons in your car, preventing the ignition from being started without the PIN code. You can enter the code manually or through the Android or Apple app. If the wrong code is entered, the app will show an indicator light. The Ghost will then not allow the vehicle to be restarted. This is a great deterrent and if the vehicle can't be started the thief will continue to pursue a new victim.

The Ghost is a weatherproof small device that is able to be hidden away in the most inaccessible parts of your vehicle. It is extremely simple to install, taking an average of 20-30 minutes for each vehicle. It is also very easy to remove if you decide to change your vehicle or return it to valet parking or service. It is a TASSA (Tracking and Aftermarket Security Systems Association) an insurance-approved system that is recognized by some insurers. It also comes with an emergency lock that is secure Pin Code Override, and a Service/Valet mode that can be activated by pressing a button in the app or by using your key fob.

Disarm

In contrast to the mechanical anti-theft devices, which are able to be removed and reinstalled, ghost immobilisers are concealed and integrated into the car. Even if they were found and stolen, thieves would not be able start the car. They are almost impossible to bypass or hack. This is because a ghost immobiliser blocks key blocking, signal jamming, and device spoofing - techniques that are used frequently by thieves to gain entry into vehicles with standard immobilisers.

An immobiliser works by sending an instruction to the ECU (electronic control unit). If the wrong code is sent, the vehicle cannot be launched as the engine will not fire up. Although it is possible to disable the ghost immobiliser using a software tool it is laborious and time-consuming. The software must be installed and operated by a authorized installer.

The Ghost immobiliser, which is a tiny device, is hidden in the vehicle's wiring loom. It is invisible to the naked eyes once installed. It doesn't show up on diagnostic systems. There are no LED indicators, and it doesn't communicate with the engine via the OBD port. It communicates in silence via the CAN data loop.

The system will not allow the vehicle to start until it is provided with an input PIN code that is entered by the user. The code is entered by pressing buttons on the steering wheel or door panels, or the centre console. This is a more secure way to safeguard your car as it does not require the use of a key fob or remote control.

In addition to this ghost vehicle immobiliser also has a service mode which can be activated by using the application on your mobile phone. This will allow you to give your keys to someone else for service or valet parking without having to enter the disarm sequence.

Whether your Ghost is in service mode or not, you should not attempt to remove the system yourself since it could impact the engine and cause damage. It is recommended to contact an installer certified by TASSA who will safely and properly remove the system. Our newest GHOST immobilisers include a special fingerprint QR sticker that is hidden in different parts of your vehicle. These are linked to our security register. In the event that the device is removed and then is sold on the blackmarket, this will allow you to trace the owner of the system.

Anti-Hijack

The anti-hijack function is a very important feature of the Ghost Immobiliser 2. This is a clever key that guards your car from thieves. If the ignition switch is turned to on, and the car is stationary for a period of 30 seconds and the Ghost system will stop the engine and switch the warning lights on. This gives the driver and passengers time to press the security button before the system is reactivated.

The Ghost system, unlike most competitors, uses an electronic timer and controller that shuts off the fuel shut-off valve 14 after a predetermined time. This is even if the ignition remains on. This delay time period must be long enough to allow the hijacked owner of the vehicle to move away from the scene of the incident and to maintain a sufficient distance from the stalled vehicle before the system can reactivate.

The Ghost has an additional layer of security to prevent common hacking techniques used to gain access to modern vehicles like relay attacks and key range expanding. The Ghost immobiliser London system communicates in a non-intrusive manner and does not emit signals that could be snatched by thieves with RF scanning or code-grabbing technology.

The Ghost system has a service / valet mode that allows your car to be temporarily started and driven without the requirement for a PIN code. This is a great option when you park your vehicle and only need to leave it briefly, such as to open the garage door or put groceries in the boot. The system will end the service mode based upon the speed and duration or through a simple PIN code input process. This gives you complete assurance that only you can drive your car!

Keyless Entry

With the growing trend in car thefts that are not involving contact numerous customers are seeking out additional security options. This is particularly true for those who have invested time or money in personalizing their vehicle or own expensive vehicles. An add-on immobiliser can be a cost-effective way to prevent this type of theft as it will stop your vehicle from starting until the right pin code is entered on your key fob.

Immobilisers are made to work with a variety vehicle circuits including those which control starter motors and fuel pumps. They also can shut down the car alarm to draw attention and scare off any potential thieves.

These devices communicate with the engine control unit (ECU) via the CAN data circuit and they stop a burglar trying to bypass it by putting in a new ECU or by using a key programmer. The immobilisers are fitted discretely and do not leave any marks on your vehicle. They are also not detected by sophisticated tools used by thieves.

In contrast to other systems that require a particular application or tag that is worn on the person carrying it the Ghost immobiliser is only disarmed by pressing a pattern of the existing electronic buttons on your steering wheel, door panel, and central console, allowing you to select a customized pin sequence. The pin can be easily changed and makes the device as secure as a credit card. It's also more difficult to break because it takes up to 20 presses.

Ghost also comes with the option of a valet/service mode that allows you to disable the system when your vehicle is going to be handed over for valet parking or service which allows it to operate within set parameters such as 30mph speed limits and you don't have to worry about your vehicle being driven in reckless manner. The system can be reactivated with the original key or corresponding entry code.

This makes it the most efficient and secure aftermarket CAN immobiliser on the market and is fully insurance-approved by Thatcham as an add-on for your car when fitted by one of our certified installers. The Ghost 2 immobiliser comes with six QR fingerprint labels as well as an ISR contact card that contains your unique QR codes, as well as an emergency code that is safe. These are all kept in your purse or wallet.