Peugeot 308 Key Fob Replacement

Peugeot 3008 key fob - gokseong.multiiq.com -'s 308 may be a bit old however it's still eye-catching. It's not the most luxurious car in its class but the Ford Focus or Volkswagen Golf will shield you from surface imperfections - but it's a relaxed and civilised drive.

Here at Coded Car Keys we are often asked to replace peugeot 308 key fobs. The following tips can aid whether the issue is ongoing or intermittent.

Water Damage

If you accidentally drop your key fob in an eddy, or it gets wet while kayaking, canoeing or rafting or canyoning the fob is most likely to be damaged by water. Keep your key fob in a dry bag every time you go outdoors or do activities that expose it to large amounts of water.

It's also essential to make sure the fob has completely dried before you open it up and then use it again. If you detect any smells coming from the fob, such as an industrial-type liquid smell or that of windshield washer fluid, it's another sign that it's submerged in water.

A wet circuit board can cause the battery to discharge its charge or even explode. If you're able to pull your key fob 308 out of the water body it got stuck in then flip the button side down and shake it out as much water as you can before opening the case. Once you have opened it, remove the battery and wipe down the circuit board with an abrasive soaked in 90 percent isopropyl alcohol.

Other reasons why your Peugeot 308 remote keyless entry system could fail to function include an empty coin battery or receiver module issue, signal interference, or an electronic chip that is damaged. If none of these are the reason, you may try resetting the system by removing the battery with 12 volts for around 15 minutes.

Dead Coin Battery

Peugeot cars are equipped with remote start technology that allows drivers to start their car from an extended distance, which allows them to warm up or cool down the car before they enter. This feature is extremely beneficial, especially during cold winter months. However, sometimes the remote start system stops working due to a variety of reasons, including the battery in the coin is dead.

The coin-shaped battery located inside the key fob could last between two and four years depending on how often it is used, where it was purchased, and how it is utilized. The date of use is usually printed on the package or listed in the instruction manual.

If the key fob is no longer functioning after being exposed to pure tapwater, you need to remove the battery and clean the electronic chip with the aid of a towel soaked in isopropyl ethanol. Then, dry the chip thoroughly before replacing it. In the event of exposure to salty or soapy water, the chip might be damaged and you'll have to replace the key fob entirely.

If you're unsure if the battery is in good condition, you can test the voltage with a multimeter set to the car's voltage range and connected to the terminals for minus and plus. The voltage should read approximately 12 to 13 volts, however, if it reads lower, the battery must be replaced. You can also reset the onboard computer by disconnecting and reconnecting the 12 volt batteries in reverse order. (positive cable first then negative cable). The engine should begin to run after this.

Faulty Receiver Module

If you aren't seeing the "Key Detected", it could be the receiver module defective. It's the part which sends out the signal when your key fob goes off. It also acts as an alarm and blocks the car from starting without the correct key.

This could be caused by several causes, such as water damage or simply getting old. If the electronic chip in your Peugeot 308 keyfob is damaged due to dirty tap water, it could be because the keyfob was exposed it. In this instance you'll need to remove it apart and thoroughly clean it with isopropyl alcohol or electronic cleaner. Once it's dry, you can put the battery back in and try again.

If the issue is not resolved, it is a good idea to visit a local Peugeot expert or locksmith. They can employ the diagnostic tool to identify the issue and repair it.

It is stressful to lose your Peugeot car key. However, a qualified auto locksmith can solve the issue in a matter of minutes. They can cut a new key and program it to your vehicle, ensuring you can get back out on the road in the shortest amount of time. Click here to find a local locksmith near you.

Faulty Electronic Chip

The electronic chip that is in the Peugeot 308 key fob is a critical role in the remote control system. If it is damaged, your car might not start, or you could receive a message that reads "anti-theft active". If this happens, the only way to fix the issue is to obtain a new key. Auto locksmiths with experience are able to provide this service within the shortest possible time.

The chip in your Peugeot 308's key fob could be damaged due to many reasons, including sweat, water damage or dirt. If your Peugeot key fob was exposed to soapy or dirty water, it should be cleaned as soon as possible. You can make use of a paper towel and isopropyl alcohol for cleaning the electronic component. Then, you need to allow the battery to dry completely.

Sometimes the key fob may be inoperable due to radio interference. This can happen when other devices operate on the same frequencies as your Peugeot keyfob. It could also be caused by weather conditions or objects that are in the vicinity of the vehicle. If you experience this problem, it is best to visit an Peugeot dealership.

The Peugeot key fob 207/308 is extremely delicate and requires special attention. It should not be dropped or throw it around. If you lose it, try to find it as soon as you can. You can reset your on-board computer by disconnection of the battery for a few minutes. Disconnect the negative cable before the positive.