Choosing a French Door Threshold Replacement

Thresholds are a necessity to fill in gaps that are uneven at the bottom of doors and offer all-season protection from bugs, draughts, and water. A lowered threshold is safer for wheelchairs, pushchairs/prams, and also connects interior and outdoor spaces more seamlessly.

It is essential to know the various options available in advising customers on their french door glass repair door threshold options.

Weathered

The threshold of an outside door is a crucial feature of any french door seal replacement. It provides protection from the elements and an effortless transition between indoor and outdoor spaces. However, it is essential to strike the right balance between security and aesthetics when selecting the threshold for an exterior door system. As well as being essential to keep the home weatherproof, thresholds play an important role in user safety by preventing tripping and also restricting access for those with mobility issues or wheelchairs. There are many threshold options that allow customers to pick the one that is best for their home.

A threshold that is weathered is an ideal choice for doors on the outside, since it offers exceptional rates of weather protection and creates an effective barrier to keep water, wind and draughts from. This kind of threshold can be recessed/sunk into the floor, leaving a 14mm upstand, minimising tripping hazards while leaving an effective seal against the elements. Weathered thresholds are recommended for all external doors as they provide greater levels of weatherproofing than unweathered alternatives. However, the higher elevation of weathered thresholds may make them unsuitable for certain users, especially those using wheelchairs or pushchairs/prams.

The thresholds that are not weathered tend to be smaller in height. Many are only millimetres off of the ground. This means they are less likely for them to cause dangers for tripping. They also provide an easier transition between indoor and French Door Threshold Replacement outdoor French Door Threshold Replacement spaces, helping to connect the two in a more open and connected way. They might not provide the same levels of weatherproofing as a weathered alternative however, they are ideal for homeowners looking to enhance the look of their home without sacrificing practicality or protection.

If your replacement french door doors are currently equipped with an unweathered threshold or you're planning to replace them, a new threshold is a DIY project that can smooth the gaps that are uneven at the bottom of doors and also shield against water ingress and drafts. It is possible to install the new threshold onto an existing sill, but the old threshold must be removed first. To remove the threshold, put a flat bar (aka pry bar) between it and the subsill, and carefully lift up the center section. If the ends of the threshold are nailed in place then use a hammer or chisel to remove them from the jambs. After taking the threshold off, sand and remove any mortar remnants. It is recommended that you spray an expanding foam sealant under the threshold before installing it again. This will hold it in place and fill any air gaps.