Fiat 500 Key Fob replacement fiat 500 key fob

If your 500 keyfob ceases working, try a different one to determine if it will be recognized by the car. If it does, then the issue may be due to the battery or water damage to the fob that was originally used.

First, replace the battery. The "+" side should be facing downwards.

Dead Battery

The battery is typically the cause of an inoperative fob. This is easy to solve and most fobs notify you that the battery is getting depleted. You can find the instructions on YouTube for nearly any key fob in your car or in the owner's manual. You can also change it by taking it to a locksmith or dealer who gave it to you.

Sometimes a fob will stop working due to a problem on the internal circuit board. This is a bit rare but it can happen. If you dropped the fob on something sharp, it could damage the internal chip. It can occur if you use an aftermarket fob and the key doesn't work. In this case, you will be required to go to a dealer or a locksmith and have it reprogRammed to work with your 500.

One 2012 FIAT 500 Flip Key Remote that resembles Ilco brand with trunk, lock and lock buttons. New replacement keyless entry remote (will need to be cut and programmed by a locksmith)

Damaged Chip

A fiat 500 key fob is an wireless device that sends the signal needed for the car to start once you press the button. It has a microchip that holds information about the code needed to communicate with your car. If the chip is damaged, it can't transmit the correct code and the car will not start. Locksmiths can fix this type damage. United Locksmith can complete this repair on both classic and modern models, so do not hesitate to contact us.

You can purchase a brand new fob and have it professionally programmed by locksmiths. This is a lot less expensive than going to a dealer and will function similarly. You'll have to provide some information for the locksmith, for example, the year in which your car was made and the model.

Rub the chip with an old dollar bill if you're not sure what to do. The copper in the bill is abrasive enough to remove dirt and oxidation, but won't cause any harm to the microchip. If the chip is physically damaged, however, it may not be repairable. This can happen when you drop it or get it pushed over by your vehicle.

Water Damage

Water damage is likely to occur on your fob, no matter if you dropped them in the pool accidentally or put them in a pocket while swimming or splashed water over them during a rainy afternoon. Even if there's only a tiny amount of water on the key, it can cause serious problems for its electronics and prevent it from functioning effectively.

It is usually possible to solve this problem by taking the fob out and cleaning it using a paper towel. Once the fob has dried and is dry, you can replace its battery. It will then begin working properly.

You could also take your fob to a local locksmith or auto shop to have it professionally cleaned and programmed. They can employ special equipment to make sure that the key fob is compatible with the computer in your car.

If the key fob on your Fiat 500 stops working, you may feel frustrated and overwhelmed. It can be expensive and difficult to transport your key fob to the dealer. Locksmiths can handle every aspect of the replacement of your car's key fob without the necessity of a dealer visit. They are a better option over a dealer as they can handle every aspect of your car's key fob replacement without the need for a dealer visit.

Pairing Issues

If you accidentally drop your keyfob, or it ceases to function and nothing else seems to be wrong, it could be the chip. This could be due water damage or a dead battery, or it could just be that you need to reprogramme it.

This is often done by simply following the instructions in the owner's manual. However, it's a good idea to have an automotive locksmith assist you if you're experiencing trouble or the instructions in the manual don't work for you. This will ensure that your chip isn't damaged and is the most affordable solution.

Another issue that plagues some 500 owners is that the key fob won't lock the car. This can be a huge issue if you're at the gas station to refill. Some owners have reported that their 500's locking system has failed and they've needed to replace the entire intermediate steering shaft. Fiat has even mentioned this problem in an technical bulletin (TSB).

If you're having issues with your Fiat or other car, an experienced locksmith could help. They'll duplicate your key, or make you an entirely new one that can lock and open the vehicle. They can do this without having access to your old key, and it's typically cheaper than buying a new one from a dealer.