Ghost 2 Immobiliser Problems

The Ghost 2 immobiliser, designed to protect cars from key cloning or hacking is a discrete device that can be installed without damaging your vehicle. It stops your vehicle from starting unless you enter the correct sequence of buttons within your vehicle like the password you enter on the phone.

Stop/Start

Ghost immobilisers protect vehicles from being stolen by preventing the engine from running until it is issued the correct PIN code. This is done without altering the vehicle, and is not detected by thieves. The unit communicates directly with the ECU via the CAN databus to lock the vehicle. This system is very similar to the one that car manufacturers have been using in their cars for many years however, the criminal isn't able to add a key or use key relay technology to bypass it as they could with factory-installed systems.

Ghost Ghost can be fitted to any vehicle, van motorhome, caravan, or bicycle that has an engine. It's compatible with all major brands of vehicles. The same system can also be used on electric vehicles. It's an excellent alternative to wheel clamps and steering wheel locks.

When the Ghost is armed it will block all the buttons in your car and stop the ignition from being started until a PIN code has been entered prior to. This can be done using the Android or Apple mobile apps or by entering the code through your key fob. If a wrong code is entered, the app will display an indicator light and the Ghost will not allow the vehicle to be started again. This is a great method to deter thieves. If the vehicle can't be started and they are unable to get it started, they will leave.

The ghost immobiliser tracker is a weatherproof, small device that can be tucked away in the most difficult to access areas of your vehicle. The installation process takes between 20 and 30 minutes for each vehicle. It is also simple to take off if you decide to change vehicles, or to give it to an auto repair shop or valet parking. It is a TASSA (Tracking and Aftermarket Security Systems Association), insurance approved system, which is recognized by certain insurance companies. It also comes with a secure emergency Pin Code Override, and the Service/Valet feature that can be activated by pressing a button in the app, or by using your key fob.

Disarm

In contrast to the mechanical anti-theft devices, which are able to be removed Ghost immobilisers are hidden and are integrated into the car. Even if they were to be found, thieves would not be able to start the car. They are virtually impossible to bypass or hack. This is because a ghost immobiliser blocks key cloning, signal jamming and device spoofing, all of which are methods that are commonly used by thieves to get into cars fitted with standard immobilisers.

An immobiliser functions by sending an instruction to the ECU (electronic control unit). If the incorrect code is received the vehicle will not be started as the engine will not fire up. Although it is possible to disable the ghost immobiliser using software, it is time-consuming and difficult. Only an authorised installer can install and use the software.

The Ghost immobiliser ghost is a small system that sits within the wiring loom of the vehicle and is not visible to the naked eye after it has been installed. It does not appear on diagnostic systems. There are no indicators with LEDs, and it isn't able to communicate with the engine via the OBD port. It communicates silently through the CAN data loop.

The system will not allow the vehicle to start until it receives an input PIN code defined by the user. This code is entered using buttons on the steering wheels or door panels, or central console. This is a much safer way to protect your car since it doesn't require a key fob or remote control.

In addition, Ghost offers the option of a service mode that can be activated through the application on your mobile phone. This lets you give your keys to someone else to use for service or valet parking, without needing to enter the disarm sequence.

You should not remove the system from your Ghost by yourself, no matter whether it's in service mode. This could cause damage to the engine. It is recommended that you contact a TASSA certified installer who can remove the system safely and properly. Our newest GHOST immobilisers come with a unique fingerprint QR sticker, which is hidden in various areas of your vehicle. They are linked to our security register. In the event that the system is removed and then sold on the blackmarket it will be able to trace the original owner.

Anti-Hijack

Ghost Immobiliser 2 has a very useful anti-hijack feature. This system functions as an intelligent key and is one of the most secure methods to protect your vehicle from theft. When the ignition switch is turned to on and the vehicle is stationary for a period of 30 seconds then the Ghost system will stop the engine and turn on the hazards lights on. This gives the driver or passenger time to press a secret security button (depending on the vehicle) before the system is activated and the engine is once again allowed to begin.

Unlike many competitor systems that simply stall the engine when the ignition is switched to on The Ghost system uses a special controller and timer unit which will shut off the valve that cuts off fuel if it is activated after the set time even when the ignition is turned on! The delay time should be long enough to allow the owner of the vehicle to get away, and be a sufficient distance from the vehicle that is stalled before the system is reactivated.

The Ghost comes with an additional layer of security to prevent common hacking techniques used to gain access into modern cars like relay attacks and key range extension. The Ghost system communicates in a non-intrusive way and does not emit signals that can be snatched by thieves using RF scanning or code-grabbing technology.

The Ghost system also comes with a Service / Valet mode that allows your vehicle to be temporarily started and driven without the need for an PIN code. This is ideal when you park your vehicle and have to leave it for a brief period of time, such as for example, to store groceries in the boot, or open a garage door. The system will exit service mode according to speed and duration or by using the easy PIN code entry process and give you assurance that only YOU are able to use your vehicle!

Keyless Entry

Many consumers are now looking for extra security measures due to the increasing trend of car thefts using contactless technology. This is particularly true for those who invested time and money into customising their car or own expensive cars. An add-on immobiliser can be an affordable method to stop this type of theft as it can prevent your vehicle from starting unless the correct pin code is entered alongside your key fob.

Immobilisers are designed to intercept various vehicle circuits, including those that control the starter motor and the fuel pump. They can also disable the car alarm in order to attract attention and deter potential thieves.

These devices are directly connected to the engine control unit through the CAN data network. They prevent the thief from bypassing it by installing a new ECU or by using key programmers. The immobilisers are fitted in a discreet manner and leave no trace in your vehicle. They are also not detected by hi-tech thieves' tools.

In contrast to other systems that require a separate app, or a tag to be worn on the person carrying it the Ghost immobiliser can only be deactivated by pressing a pattern of the existing electronic buttons on your steering wheel, door panel and the centre console, which allows you to select a customized pin sequence. The pin can be changed as frequently as you'd like, meaning it's as secure as a credit card and can be even more difficult to hack because it requires up to 20 presses.

Ghost also offers the option of a valet/service mode that lets you deactivate the system when your vehicle is going to be handed over to valet parking or service and allows it to operate within predetermined parameters, like a 30mph speed limit which means you don't need to worry about your vehicle being driven at a reckless speed. The system can be reactivated with the original key or corresponding entry code.

Installed by our accredited installers and certified installers, it is the most secure and reliable aftermarket CAN-immobiliser available. It is also certified by Thatcham for insurance purposes. The Ghost 2 immobiliser comes with six QR fingerprint labels, as well as an ISR contact cards containing your unique QR codes as well as an emergency code that is secure. They are all stored in your wallet or purse.