Peugeot 308 Key Fob Replacement

Peugeot's 308 might be a little old but it's still eye-catching. It might not be the plushest car in its class and an Ford Focus or Volkswagen Golf will protect you from sloping surfaces - but it's a relaxing and a civilized drive.

Here at Coded Car Keys we are often asked to replace peugeot 308 key fobs. The following suggestions will help whether the problem is intermittent, or constant.

Water Damage

If you accidentally drop your key fob into an eddy, or it is wet while kayaking, canoeing or rafting or canyoning the fob is most likely to be damaged by water. Keep your key fob in a dry bag whenever you go outside or engage in activities that expose it to large amounts of water.

You'll also want to ensure that the fob is completely dry before opening it up and reusing it. If you detect any smells coming from the fob, such as an industrial-type liquid smell or the scent of windshield washer fluid, this is another indication that it's submerged in water.

A circuit that is wet can cause the battery's power to be depleted or even explode. If you're able, if you can, pull the 308 key fob of the water in which it got stuck in it, flip the button side down and shake out as much water as you can before opening the case. After you open it, take out the battery and clean the circuit board using the help of a cotton swab that has been dipped in 90-percent isopropyl alcohol.

Other causes why your Peugeot 308 remote entry keyless system might not work include a dead coin-cell battery or receiver module issue signal interference or a defective chip. If none of these is the issue, try resetting the system by disconnection of the battery at 12 volts for approximately 15 minutes.

Dead Coin Battery

Peugeot cars come with a remote-start system which allows the driver to start the replacement car keys peugeot from a distance by warming up or cooling down the vehicle prior to stepping inside. This feature is extremely helpful particularly during the winter's cold and chilly months. However, sometimes the remote start system ceases working due to a variety of causes, such as the battery in the coin is dead.

The coin-shaped battery located inside the key fob can last between two and four years depending on how often it is used, where it was purchased and how it is used. The date for use-by will be printed on the package or marked in the user manual.

If the key fob has stopped working after exposure to water that is clean, remove the battery and clean the electronic chip with the help of a paper towel that has been soaked with isopropyl ethanol. Then dry the chip completely before replacing. In the event of exposure to salty or soapy water, the chip may be fried and you will have to replace the key fob completely.

If you're unsure if the battery is defective it is possible to test the voltage with a multimeter set to the car's voltage range and connected to the terminals for minus and plus. If the voltage is lower than 12-13 volts you should replace the battery. If you want to, you can try to reset your on-board computer by disconnecting the battery with 12 volts for a few minutes and reconnecting it in reverse order (positive cable first and then negative). The engine should begin to run after this.

Faulty Receiver Module

If you aren't seeing the "Key Detected" message, it could mean that your receiver module is not working properly. It's the component that sends out an alert when your key fob activates. It also acts as an alarm and blocks the car from starting without the correct key.

This could be due to a number of causes, such as water damage or simply the aging process. If the electronic chip inside your Peugeot 308 keyfob is damaged due to dirty tap water, it could be because the keyfob was contaminated with it. In this situation it is necessary to take it apart and thoroughly clean it with isopropyl alcohol or electronic cleaner. When the battery is dry, you can try again.

If the issue persists then it's a good idea to seek out a local Peugeot specialist or locksmith. They will be able to utilize a diagnostic tool to help pinpoint the issue and fix it.

Losing your Peugeot car keys can be an emotional experience. A certified auto locksmith will be able to solve the problem within minutes. They can cut a brand new key and program it to your vehicle, making sure you're back to the road as fast as you can. Click here to find a locksmith near you.

Faulty electronic chip

The electronic chip in the Peugeot 308 key fob plays a vital function in the remote control system. If it is damaged, your car might not start or you may receive a message saying "anti-theft active". If this occurs, the only solution to fix the problem is to purchase a new key. Fortunately, auto locksmiths with experience are able to provide this service within the shortest period of time.

The chip inside your Peugeot 308's key fob may fail due to various reasons, such as sweat, water damage or dirt. If your peugeot key fob replacement key fob was exposed to soapy or dirty water, it needs to be cleaned promptly. You can clean the electronic component using the help of a towel that is soaked in isopropyl Alcohol. The battery must then be allowed to completely dry.

Sometimes the key fob may stop working because of radio interference. This could be caused by other devices that operate on the same frequency as your Peugeot key fob. It could also be caused by weather conditions or objects in the vicinity. It is recommended to visit a Peugeot dealer if you experience this issue.

The Peugeot Key Fob 207/308 is very delicate and requires particular care. You shouldn't drop it or throw it around. If you lose something, try to locate it as soon as you are able to. You can reset all on-board computers by disconnecting the 12 volt battery for a short period of time. Remove the negative cable before the positive.