How to Replace a Nissan Juke Spare Key

Nissan Juke is an attractive and fun hatchback with distinctive engine configuration. It's noisy, but still fun to drive.

Replace the battery for the key fob of your Nissan Juke every two years, or when it is low. You can do it yourself, however you'll require some tools.

Dead Coin Battery

If your Nissan Juke key fob isn't working the first thing to look at is the coin battery that is inside it. It may be dead and needs to be replaced, which is a simple fix that takes just some minutes. It's as easy as flipping the fob upside down and removing the small latch/release on the back. Replace the battery you have previously installed and ensure it's facing down on the fob. Line up the two halves of the fob carefully.

If the fob was exposed to water, it will need to be cleaned prior to putting the new battery into. You can clean the fob using isopropyl or electronic cleaner and a towel. Then let it dry completely before installing the battery.

The key fob also needs to be connected with the vehicle to be able to start the car. This is done by following the directions in the owner's manual, or an OBDII scanner. If the key fob is not been linked, it is most likely the reason of why it isn't working. It could also be that the fob has malfunctioning chips, but this is a rare occurrence. In this scenario, a new receiver module might be needed. If this is the scenario, the module will need to be replaced by a certified technician.

Water Damage

The key fobs are battery-operated and the batteries need to be replaced every two years, or as soon as your vehicle stops responding when you hit the "start" switch. The key's rubber seals keep water out, but submerging the key fob in the ocean or in pool water can damage the electronic chip. If this is the case you'll have to purchase a replacement key for nissan micra key from Nissan or a locksmith.

If the key fob has a working chip, it's likely that the computer has lost its connection to it, and this could be the result of a variety of reasons. This can be fixed by restarting the car. If the "Key ID error" message continues to appear it is necessary to contact Nissan for assistance.

Three common causes are a dead battery on the key fob and a key that's not programmed, or a damaged key fob. The first two are relatively easy to resolve, while the third is more difficult to identify and repair on the spot, however it can be fixed with a bit of perseverance. Compare Nissan Key Replacement prices near you with WhoCanFixMyCar and schedule your repair online. You can read customer reviews about local Nissan dealerships, Nissan mechanics, and garages in a matter of seconds.

Faulty Chip

The key fob on your Nissan Juke contains a special chip that transmits a message to the vehicle each time you turn it. If the chip is damaged, it can cause the key to cease working. In this instance, you can only fix the problem by replacing the key. Your Nissan Juke key may be defective due to a variety of reasons, such as water damage or a dead battery for the coin.

If your key fob stops working after an immersion in the wash or bath, you need to check the chip for water damage. Check that the metal clips that hold the chip are secure. Also, ensure that the chip isn't surrounded by water. If you notice any signs of water damage to the electronic component, you should remove the battery and wipe it down with isopropyl-ethanol or electronic cleaner.

If the chip is defective If the chip is defective, you'll need to call your local locksmith or dealer. They will need the year as well as the model, make and year of your vehicle in order to find an alternative. You will also have record your VIN (Vehicle ID Number) so that the dealer, or locksmith will know which key you own. This will allow them to locate the correct key code and make sure that they cut the correct one.

Faulty Receiver Module

The key fob sends radio frequency signals to your car that performs several functions. The key fob can unlock your trunk when you are rushing with groceries to the car or start your car by pressing an icon on the fob. It can also open your windows and turn on the horn in the event you lock your keys inside your car.

If the key fob stops working, there may be a problem with the receiver module within the vehicle. The receiver modules are tuned to ensure that they can pick up specific frequencies which correspond to the signals transmitted by Nissan key fobs. If your car has an inoperable receiver module it will not respond to any signal received from the key fob.

Whatever way your Nissan key fob is damaged, it is always good to have a spare key in case the key gets lost or broken. A spare key can be programmed by a locksmith or dealership to work with your Nissan and assist you in avoiding the anxiety of locking your keys inside your car or losing them.

If your Nissan Juke key fob is exposed to clean rain or tap water it is possible to have the issue cleaned with isopropyl alcohol or an electronic cleaner. If the chip is damaged you will need to purchase the new keyfob, which can be coded for your vehicle by a dealer or locksmith.