How to Replace a Nissan Juke Spare Key

Nissan Juke is an attractive and fun hatchback that features a unique engine configuration. It's a bit noisy, but it's enjoyable to drive.

The key fob battery in your nissan juke needs to be replaced every two years or every two years, or when it's low. It is easy to do at home, but you'll need a few tools.

Dead Coin Battery

If your Nissan Juke key fob isn't functioning, the first thing to look at is the coin battery inside it. It could be dead and need to be replaced. This is a simple fix that will take only several minutes. Flip the fob upside down so that you can access the tiny latch/release at the back. Replace the battery that was in use and ensure it's facing down on the fob. Place the two halves of the fob carefully.

The fob should be cleaned if it has been exposed water before you can install the new battery. This can be accomplished using a paper towel along with isopropyl alcohol or electronic cleaner, and then let it dry completely before inserting the battery.

The key fob has to be paired with the car to start it. This is done by following the instructions in the owner's manual or an OBDII scanner. The most likely reason the key fob was not working is that it was not connected to the car. A malfunctioning chip inside the fob can cause it to cease to function however this is extremely rare. In this scenario, a new nissan key receiver module could be required. If this is the case the receiver module will need to be replaced by a skilled technician.

Water Damage

Key fobs operate on batteries and the batteries must be replaced every two years or at the point that the car stops responding when you push the "start" switch. The rubber seals on keys keep out water, but submerging the key fob in the ocean or in pool water can damage the electronic chip. If this happens, you will need to obtain a new key from Nissan or an automotive locksmith.

If the key's chip is an operating chip it's likely that the computer has simply lost its connection to it, and this could occur due to a variety of reasons. A simple restart of the car can fix this, but if the key's still displaying the "Key ID" error message, it's best to contact Nissan or an auto locksmith to get help.

Three common causes are a dead battery for the key fob, a key that is not programmed, and a damaged key fob that is damaged. The first two issues are fairly simple to fix and the third one is more difficult to identify and repair but is fixable with patience. Compare Nissan Key Replacement costs near you using WhoCanFixMyCar, and book your repair online. It only takes minutes and you can read reviews from local garages, Nissan car mechanics and dealerships before you decide.

Faulty Chip

The key fob on your Nissan Juke contains a special chip which sends a message to the vehicle whenever you turn it. If that chip is faulty, it can cause the key to cease working. If this happens the issue can be resolved only by replacing the key. The Nissan Juke key could be defective for a variety of reasons, such as water damage or a dead coin-battery.

Check the chip for any water damage when your key fob stopped working after a bath or wash. Verify that the metal clips that hold the chip are securely. Also, ensure that the chip isn't exposed water. If you observe any signs of water damage on the electronic component, you should remove the battery and clean it with isopropyl alcohol or electronic cleaner.

If the chip is not working You'll need to contact your local locksmith or dealer. They will need the year the make, model, and year of your vehicle to locate a replacement. It is also necessary to write down your VIN (Vehicle ID Number) to ensure that the dealer or locksmith will know the key you have. This will enable them to search for the correct key code, and also ensure that they are cutting the right one.

Faulty Receiver Module

The key fob transmits a radio signal to your vehicle, allowing it to perform various functions. It can unlock the trunk as you rush to get groceries or start your car by pressing the button on the fob. It can also open your windows and turn the horn on in the event that you lock the keys in your car.

If the key fob does not work, it may be due to a glitch in the receiver module. The receiver modules are tuned to detect specific frequencies that correspond with the signals generated by the Nissan key fob. If your car is equipped with a faulty receiver module it will not respond to any signal coming from the key fob.

Regardless of how your Nissan key fob gets damaged, it is always beneficial to have a spare key in case the key becomes damaged or lost. A locksmith or dealer can program the spare key to work with your Nissan. This can help you avoid the hassles of losing your keys or locking them in your car.

If your Nissan Juke key fob has been exposed clean tap water or rain, the problem could be resolved by cleaning it with isopropyl ethanol or electronic cleaner. However, if the chip has deteriorated and you need to purchase a replacement key fob that can be programmed to your car by a locksmith dealer.