Double Glazed Window Repair

It's worth checking the warranty included with most double-glazed windows. It usually covers any problems with window hardware, like hinges and locking mechanisms, in the first ten years.

The mist that forms between the glass windows is usually caused by a break in the seal and must be fixed quickly to prevent damp or mould growing in your home.

Condensation Between the Windows

If you notice condensation appearing between your windows, this is an indication that the seal in the gases that insulate the window has failed. This can be a serious issue that should be addressed as soon as possible especially in winter when humidity is at its highest. It can also cause damage to the sills, sealant, or even mould or mildew.

Ideally double-glazed windows shouldn't have condensation between the panes. This issue could be caused by extreme humidity or a cold snap. Fortunately, this issue is fixable without replacing the entire window. A professional can make small holes into the glass and then spray the inside of the window with a special cleaning solution. The water is then removed from the window and an anti-fogger device can be fitted to prevent further accumulation of moisture in the future.

Condensation can also occur between windows due to air leakage, or other causes outside the window. If this is the case, it will likely take longer for moisture to gather in the window as the air will need to be warm enough for the water molecules to evaporate. In these cases it is recommended to replace the double-glazed windows rather than repair the seals on the existing units.

A double-glazed window is made consisting of three or two pieces of insulated glass that are held together by a metal frame. The gap in the middle of the window is filled with a non-toxic gas for insulation such as argon or krypton and then sealed. The seal blocks the insulating gases from escaping and also prevents moisture and air from getting into the gap.

As windows age, seals may be damaged, allowing moisture to enter between the glass panes. When seals fail it is crucial to recognize this as it means that the double glazing isn't performing as well as before. This could lead to poor energy efficiency, increased heating bills, damage to the properties and the risk of condensation between the windows.

Mist

It is normal to observe condensation on your windows. This indicates that your double glazing system is functioning correctly and is able to maintain heat in your house. The condensation is caused by the outside air is hotter than the glass, and reaches the dew point of the window before the air inside. This is among the many advantages of having high quality double glazing.

If you see condensation on the inside of your window, this could be a sign of a ventilation issue within your home. The moisture that is accumulating can't go anywhere else and ends up on the carpets, windows furniture, and other parts of your home. It is recommended to have this checked by an expert and making sure that there is plenty of fresh air moving through the home will help avoid it from happening again.

Another reason you could get mist in your double-glazed window is that the seal between the two panes has broken down. This could be due to wear and tear, or due to the use of chemical cleaning products. If this is the case the best solution is to have the windows repaired in the shortest time possible.

A professional repair of your windows will ensure that they remain clear of fog free of condensation and free of misting. It is also a lot cheaper than replacing them entirely and door will also reduce your energy bills.

A FENSA registered window installer can provide you with a cost estimate for the repair upvc windows or replacement upvc door panel of your double glazed windows. If your existing windows are very old and have been in use for a long time, you may want to think about changing them to new A-rated energy efficient windows.

It is best to keep copies of any agreements and warranties with the window installers. This will be very helpful should any issues with the windows arise in the future, and you then contact your installers to resolve the issue. This is a better choice to ignore the issue and causing further problems in your home.

Difficulty to Open or Close

It's not just a nuisance when double-glazed windows are hard to open or close. They could also lead to more expensive energy bills due to the loss of heat and draughts. It could also be a security risk, especially if the locks don't work properly. It is recommended to fix double-glazed windows and doors in the earliest time possible.

If you are unable to open your window and have tried the most basic of solutions like using a screwdriver to pry it open or rubbing the frame with a hard object, then the issue could be more serious. The window may have moved and needs to be re-set or there may be a gap in between glass and frames. In either of these scenarios, you must seek out an experienced double glazing repair expert to ensure that the proper repairs are made to prevent any further problems.

It is not unusual to find upvc windows sale window handles and lock mechanisms to become difficult to operate or get stuck, especially if they are old and worn. This is usually due to the accumulation of grease or dirt in the handle. This can be easily resolved by cleaning it using a upvc door hinges cleanser. If this doesn't help, you could try gently tapping the uPVC frame with a hard object such as a screwdriver, being careful not to scratch the handle or the window handle mechanism.

If this doesn't resolve the problem then the window might need to be replaced, since it is likely that the hinges aren't more in the proper position, or the locking mechanisms are damaged. In this case you should speak to a upvc door handles window expert.

David The Window Wizard specialises in all technical aspects of double glazed window and door repair including fixing a jammed or shut double glazed window. He has extensive experience with converting discontinued window mechanisms to modern ones. This often can save you the cost of replacing the whole window. For more information or to request a free quote call or email us today.

Warping

Double-glazed windows can be an excellent way to save energy in your home. They consist of two separate panes that have a spacer or dense gas in between them. This creates a seal which keeps cold air out and warm inside. However with time, these windows can be damaged or destroyed and require repair. Most repairs can be done without having to replace the entire window.

A common issue that double-glazed windows face is warping. This occurs when windows begin to flex or twist or bow. This can impact the structural integrity and insulation properties of the windows. The best method to avoid this problem is to make sure that your double-glazed windows are fitted properly and maintained regularly.

If your double-glazed windows are beginning to warp, it is essential to speak with a professional immediately to stop the issue from becoming worse. They will be able to inspect your windows and determine the cause of the warping. They will then employ special tools to correct the issue and ensure that your windows are sealed.

Water vapour can cause this issue because it can build up between the windows over time. This could be due to a variety of elements, such as the weather conditions such as humidity levels, temperature and changes. To fix this the expert will drill tiny holes in the glass to let out the moisture. The specialist will apply an agent for cleaning on the glass to cleanse it and then apply an adhesive.

In the alternative, if your windows aren't being shut or opened, it could be a sign of a break in the mechanism or hinges. It is recommended to lubricate the areas of the window prior to calling a professional since this will often resolve the issue and decrease the need for replacements. However, if your windows are old or do not provide the insulation you would like to see it is usually better to replace them.