How to Replace a Nissan Juke Spare Key

Nissan Juke is a fun and stylish hatchback that features an unusual engine configuration. It's quite noisy but still a blast to drive.

Replace the key fob battery of your nissan juke key fob replacement Juke every two years, or when it's at a low. It's simple to do at home, however you'll need a few tools.

Dead Coin Battery

If the key fob in your Nissan Juke is not working, check the battery for coins. It could be dead and need to be replaced. This is a simple fix that only takes some minutes. It's as easy as flipping the fob upside down and accessing the tiny latch/release located on the back. Replace the battery you have previously installed with the new one, making sure it's facing the bottom of the fob. Line up the two halves in a careful manner.

If the fob was exposed to water, it needs to be cleaned prior placing the new battery into. This can be accomplished by using a paper towel and isopropyl alcohol or electronic cleaner, and waiting for it to dry completely prior to re-inserting the battery.

The key fob must also to be connected to the car to be able to start the car. This can be accomplished by following the directions in the owner's manual or an OBDII scanner. The most likely reason why the key fob was not working is because it was not linked to the car. It is also possible that the fob is equipped with defective chip, however this is extremely rare. A new receiver module may be needed in this case. If this is the case it should be replaced by an expert technician.

Water Damage

The key fob is battery operated, and these batteries must be replaced every two years or so, or at the first sign of your car not responding when you hit the "start" button. The keys' rubber seals protect them from water, however submerging a key fob in the pool or ocean can damage the chip's electronic. If this happens you'll require a new key from Nissan or an automotive locksmith.

It's possible that the computer lost connection to the key fob This could be due to a variety of reasons. This can be resolved by restarting the car. If the "Key ID error" message continues to appear it is necessary to contact Nissan for assistance.

Three common causes are a dead battery for the key fob, a key that is not programmed, and a damaged key fob. The first two are easy to resolve, and the third is harder to diagnose and repair on the spot, however it is generally fixable with a bit of perseverance. Compare Nissan Key Replacement costs near you using WhoCanFixMyCar and book your repair online. Read reviews about local Nissan dealerships, Nissan mechanics, and garages in a matter of moments.

Faulty Chip

The key fob of your Nissan Juke contains a special chip that transmits a signal to the vehicle when you turn it. The key may stop working if the chip is faulty. If this is the case the issue will only be resolved by replacing the key. There are a myriad of reasons your Nissan Juke's key might be defective, including water damage, a dead coin battery or a damaged receiver module.

Check the chip for any water damage If your key fob has stopped working after a bath or wash. Make sure the retaining clips on the chip are tight. Also, make sure the chip isn't exposed to water. If you spot any signs of water damage to the electronic component, you should remove the battery and clean it with isopropyl-ethanol or electronic cleaner.

If the chip is faulty If it is damaged, you should visit the local locksmith or dealership. They will need the year model, make, and year of your vehicle in order to find an appropriate replacement. You'll also need note down your VIN (Vehicle ID Number) so that the dealer, or locksmith will know which key you own. This will allow them to verify the correct key code, and ensure they are cutting the correct key.

Faulty Receiver Module

The key fob sends a radio frequency signal to your car, enabling it to perform several functions. It can unlock the trunk while you rush to the car with groceries or start your car by pressing the button on the fob. It can even open your windows and switch on the horn should you have a mishap and lock your keys inside the car.

If the key fob stops functioning, there could be an issue with the receiver unit in the vehicle. The receiver modules are tuned so they can detect specific frequencies that correspond to signals that are transmitted by Nissan key fobs. If your car has malfunctioning receiver modules is damaged, it will cease to respond to any signal sent by the key fob.

Regardless of how your Nissan key fob is damaged, it is always good to have a spare key in case the key becomes damaged or lost. A spare key can be programmed by a locksmith or dealership to work with your Nissan and assist you in avoiding the anxiety of locking your keys inside your vehicle or losing them.

If your Nissan Juke key fob has been exposed pure rain or tap water the issue can be solved by cleaning it with isopropyl alcohol or an electronic cleaner. If the chip has fried, you will need to purchase a new keyfob which can be coded for your vehicle by a locksmith or dealer.