Peugeot 308 Key Fob Replacement

peugeot keys's 308 may be catching on a little but it's still attractive. It's not the most luxurious vehicle in its class, but it is a pleasant and peaceful drive.

Here at Coded Car Keys we are often asked to replace peugeot 308 key fobs. Whether the problem is ongoing or continuous the following tips will help.

Water Damage

If you accidentally drop your key fob into a puddle, or if it gets wet while kayaking, canoeing or rafting or canyoning the fob is most likely to be damaged by water. The best way to stop this from happening is to keep it in a dry bag whenever you're outside or performing things where the fob might be exposed to a lot of water.

It's also crucial to make sure that the fob is completely dried out prior to opening it to use it again. If you detect any smells emanating from the fob like an industrial liquid smell or that of windshield washer fluid, it's another indication that it's submerged in water.

A wet circuit board can cause the battery's charge to drop its energy or even explode. If you can pull the 308 keyfob from the water you need to turn the button side up and shake as much water as you can before opening the casing. Remove the battery, then clean the circuit board with a cotton swab that has been submerged in 90 percent alcohol.

Other causes why your Peugeot 308 remote entry keyless system may not function include a dead battery in the coin-cell or receiver module issues signal interference or a malfunctioning chip. If none of the above is the problem, you can reset the system by disconnecting 12 volt battery from your vehicle for 15 minutes.

Dead Coin Battery

Peugeot cars are equipped with a remote-start feature that allows the driver to start the car from afar and then warm up or cool down the vehicle prior to entering. This feature is extremely helpful particularly during the winter's cold and chilly months. However, sometimes the remote start system ceases working due to a variety of reasons, including an unresponsive coin battery.

The coin-shaped battery contained inside the key fob could last between two and four months, depending on how frequently it is used, the location it was purchased, and how it is used. The use-by date will be printed on the package or mentioned in the user's manual.

If the key fob has stopped working after exposure to water that is clean it is recommended to take the battery off, clean the electronic chip using a paper towel and isopropyl alcohol, and then dry it completely before replacing it. If the key fob was exposed to salty or soapy water, it may have caused the chip to be damaged. You'll need to replace it.

If you're not sure whether the battery is in good condition you can check the voltage using a multimeter attached to both the terminals for plus and minus. If the voltage is lower than 12-13 volts, you must replace the battery. You can also reset your computer that is onboard by disconnecting and reconnecting the 12 volt batteries in reverse order. (positive cable first then negative cable). The engine should start.

Faulty Receiver Module

If you're not seeing the "Key Detected" message on your dashboard, then it's possible that your receiver module has discovered a problem. It's the part that sends an indication to the car when the key fob is activated which also acts as an immobiliser and prevents it from starting until the correct key is in place.

This could be caused by many factors, including water damage or simply aging. If your Peugeot 308 key fob has been exposed dirty tap water, for instance, the electronic chip inside the device will be damaged. In this instance, you'll have to remove it and thoroughly clean it using isopropyl or electronic cleaner. Once it's dry, you can put the battery back in and try it again.

If the issue is not resolved, it is a good idea that you visit the local Peugeot expert or locksmith. They can use an instrument for diagnosing to pinpoint the problem and repair it.

It is stressful to lose your Peugeot car key. A qualified auto locksmith can solve the issue in minutes. They can cut a new key and programme it to your vehicle, ensuring you're back off the road as fast as you can. Click here to find a locksmith near you.

Electronic chip that is malfunctioning

The electronic chip that is in the Peugeot 308 key fob plays a crucial role in the remote control system. If it becomes damaged, your car might not start or you might get a message saying "anti-theft active". If this occurs, the only way to fix the issue is to get a new key. Luckily, auto locksmiths who are professionals can provide the service within the shortest period of time.

The chip inside your Peugeot 308's key fob could fail due to various reasons, including sweat, water damage, or dirt. If your Peugeot 308 key fob is exposed to soapy water, you must cleanse it immediately. You can make use of a paper towel and isopropyl ethanol to clean the electronic component. After that, you should allow the battery to completely dry.

Radio interference can cause the key fob's functionality to cease. This can be caused by other devices that operate on the same frequency as your Peugeot key fob. This can be caused by unsafe conditions or objects that are close to the vehicle. It is recommended to visit a Peugeot dealer if you experience this problem.

The Peugeot Key Fob 207/308 is very delicate and requires particular care. You shouldn't drop it or throw it around. If you lose something, try to locate it as soon as you are able to. You can reset the on-board computer by disconnection of the battery for a couple of minutes. Remove the negative cable before the positive.