Double Glazed Window Repair

It's worth looking over the warranty that comes with most double-glazed windows. It generally covers any issues with the hardware of the window including hinges and locking mechanisms - within the first 10 years.

A break in the seal can be the reason for mist to form between your glass windows. This issue must be repaired immediately to avoid mould or damp forming in your home.

Condensation Between the Windows

If you notice condensation forming between your windows, this is an indication that the sealing in the insulating gases has failed. This is a serious issue that should be addressed immediately, especially during the winter months when humidity levels are at their highest. It could cause damage to the sills and sealant, and even mould or mildew.

Double-glazed windows should not have condensation between the panes. This problem could be caused by excessive humidity or a particularly cold snap. This problem is usually resolvable without the need to replace an entire window. A professional can drill small holes into the glass and spray the inside of the window with a special cleaning solution. The water is then removed from the window. Additionally, an anti-fogger can be installed to prevent the accumulation of moisture from happening again.

Condensation can also occur between windows due to air leakage, unit or any other cause outside the window. In this instance, it may take longer for the moisture inside the window to build up as the air must be sufficiently warm to evaporate the water molecules. In these cases, it is better to replace double-glazed windows than attempt to repair the sealed units.

Double-glazed glass windows are comprised of two or more pieces of tempered, insulated glass that are joined by a metal frame. The gap between the two of the windows is filled with a non-toxic gas for insulation like argon or Krypton and then sealed tightly. The seal is responsible for stopping the insulating gas from escaping and also prevents moisture and air from entering through the gap.

As windows get older, the seals get worse and allow moisture to enter the gap between the glass panes. If the seals begin to leak, it is important to be aware of this since it signifies that the double glazing is no longer performing the way it did in the past. This could lead to lower efficiency in energy use, higher heating bills, property damage and the risk of condensation forming between windows.

Mist

If you notice condensation on the outside of your windows, it is normal and means that your double-glazed is functioning properly and retaining the heat in your home. The condensation occurs because the air outside is warmer than the glass and it reaches its dew point before the window does. Double glazing of high quality is a great way to accomplish this.

If you see condensation on the inside of the window, this could indicate a ventilation issue in your home. The excess moisture can't go anywhere else and ends up on the carpets, windows furniture, and other areas of your home. The process of having this examined by an expert and ensuring that there is plenty of fresh air flowing through your home will help avoid it in the future.

Another reason for mist to appear on double-glazed windows is because the seal between two glass panes has broken. This can be caused by wear and tear or due to the use of chemical cleaning products. The most effective solution is to get the windows repaired in the shortest time possible.

Professionally repairing your windows will ensure they remain fog-free free of condensation, and free of misting. It is also less expensive than replacing your windows and you will save money on your energy bills.

A FENSA registered window installer will provide you with a quote for repair or replacement of your double-glazed windows. Upgrade your windows to energy efficient ones that are A-rated in the event that they are extremely old.

It is a great idea to keep copies of any warranties and agreements with your window fitters. It can be helpful in the event that you encounter any issues with your windows. You can contact your window fitters and resolve the issue. This is better to ignore the issue which could cause more problems for your home.

The difficulty of opening or closing the door

Double-glazed windows become difficult to open and close, it's not just a nuisance but it could also result in increased energy bills due to loss of heat and drafts. It can also be a security problem, particularly when the locks aren't functioning properly. It is vital to fix any issues with double-glazed windows and doors immediately you notice them.

If you are unable to open your window and you've tried the most basic of solutions such as using a screwdriver to pry it open or rubbing the frame with a hard object, the issue could be more serious. The window may have shifted and requires a reset or there could be a gap in between glass and frames. In either case, consult a double-glazing repair expert to ensure that the repairs to upvc doors are done correctly and to prevent any further problems.

It is not unusual for upvc door replacement panel window handles and lock mechanisms to become difficult to operate or stuck particularly when they're old and worn. This is caused by an accumulation of dirt or grease within the handle. It can be solved by cleaning it with a upvc door locks replacement cleaner. If this doesn't work, try tapping the uPVC using a screwdriver. Be careful not to harm the handle or the window handle mechanism.

If this doesn't solve the issue, then the window may have to be replaced, since it is likely that the hinges are no longer in the correct position or the locking mechanisms are damaged. In this instance, you must seek out a professional UPVC window repair expert.

David The Window Wizard specialises in all technical aspects of double glazed window and door repair including fixing a jammed or locked shut double glass window. He has vast experience changing old window mechanisms to modern ones and will often reduce the cost of replacing the whole window. Contact us today for more details or a no-cost quote.

Warping

Double-glazed windows are an excellent way to save energy in your home. They are made up of two distinct panes, with a spacer gas or air between the panes. This creates an airtight seal that keeps cold air out and warm air inside. However in time, these windows can be damaged or destroyed and require repair. Luckily, most of these repairs are easy and can be accomplished without the expense of replacing the entire window.

One of the most common issues double-glazed windows encounter is warping. The windows begin to bow or unit twist, or bow. This can impact the structural integrity and insulating abilities of the window. The best method to avoid this problem is to make sure that double-glazed windows are installed correctly and maintained regularly.

If your double glazed windows are starting to crack, it's important to contact a specialist immediately to stop the problem from getting worse. They will be able to inspect your windows and determine the reason for the warping. They will use special tools to fix your issue and ensure that your windows are fully sealed again.

Water vapour is a cause of this problem, as it may build up between windows over time. It can be caused by a variety of factors, such as the weather conditions as well as humidity levels and temperature variations. To resolve this issue the expert will make tiny holes in the window to release the moisture. They will then use an agent for cleaning to wash the glass and then apply a sealant to help protect it from moisture in the future.

If your windows aren't able to be opened or shut, it could be due to a damaged mechanism or hinges. It is worth trying to lubricate these parts of the window prior to calling a professional as this can often solve the issue and decrease the necessity for replacements. If your windows are very old or are not providing the level of insulation that you would like to see It is generally better to replace them.