Ghost 2 Immobiliser Problems

Created to guard vehicles from hacking and key cloning, the Ghost 2 immobiliser is a discreet device that can be installed without damaging your car. It stops you from starting your vehicle unless you press the correct sequence of keys in your vehicle. It is similar to the mobile password.

Stop/Start

Ghost Immobilisers stop vehicles being stolen by stopping the engine from running unless it receives the correct PIN code. This is accomplished without any modification to the vehicle and is completely undetectable by thieves. The unit communicates with the ECU on the CAN data bus to immobilise the vehicle. This system is similar to the one that automobile manufacturers have used in their cars for many years However, thieves cannot add a new key or use key relay technology to bypass it as they can with factory fitted systems.

A Ghost can be fitted to any van, car, motorhome, caravan or bicycle with an engine. It's compatible with all major brands of vehicles. The same system can also be used on electric vehicles. It's a great alternative to locking the steering wheel and wheel clamps and can be installed with minimal effort.

When the Ghost is activated, it will block all the buttons in your vehicle and prevent the ignition from being started without a PIN code having been entered prior to. This can be done using the Android or Apple mobile app or by manually entering the code via your key fob. If a code that is incorrectly entered, the app will show an indicator light and the Ghost will not allow the vehicle to start again. This is a great deterrent, and in the event that the vehicle cannot be initiated, the criminal will then move on to a different target.

The Ghost is small weatherproof device that can be concealed in the most difficult to access parts of your car. Installation takes between 20 and 30 minutes for each vehicle. It is also very easy to remove if you decide to move your vehicle around or give it away for service or valet parking. It is a TASSA (Tracking and Aftermarket Security Systems Association), insurance approved system that is recognized by some insurers. It also comes with an emergency security feature that is secured by Pin Code Override, and a Service/Valet mode that can be activated by pressing a button on the app or by using your key fob.

Disarm

Ghost immobilisers, unlike mechanical anti-theft devices that are able to be removed, are hidden inside the vehicle. Even if they were found and stolen, thieves would not be able to start the car. They are nearly impossible to bypass or hack. A ghost 2 immobiliser installation immobiliser is able to prevent key cloning and signal jamming and devices spoofing. These are methods that thieves employ to gain access into cars that have standard immobilisers.

An immobiliser works by sending a code to the ECU (electronic control unit). If a wrong code is received, the vehicle cannot be started as the engine will not fire up. While it is possible to disable the ghost immobiliser by using a software tool this is very lengthy and complicated. Only an authorized installer can install and use the software.

The Ghost immobiliser, a tiny device, is hidden within the wiring loom of the vehicle. It is inaccessible to the naked eyes once installed. It is not visible on diagnostic systems. There are no LED indicators and it does not communicate with the engine via the OBD port. It communicates silently through the CAN data circuit.

The system will prevent the vehicle from starting unless it is able to receive a user-defined PIN code sequence. The code is entered by pressing buttons on the steering wheels and door panels as well as the the centre console. This is a more secure method of protecting your vehicle since it doesn't require keys or a remote control.

In addition to this Ghost has a service mode which can be activated by using the application on your mobile phone. This will allow you to give your keys to someone else for service or valet parking without entering the disarm sequence.

You should not remove the system on your Ghost by yourself, no matter whether it is in service mode. This can damage your engine. It is recommended to contact an TASSA-certified installer who can safely and effectively remove the system. Our latest GHOST immobilisers include a special fingerprint QR sticker, which is hidden in different parts of your vehicle. These are linked to our security register. If the system is removed and later sold on the blackmarket it will be able to trace the owner of the system.

Anti-Hijack

Ghost Immobiliser 2 has a highly effective anti-hijack function. This system works like an intelligent key and is one of the most secure ways to keep your car safe from thieves. The Ghost system will automatically activate the hazard light and stall the car's engine when the ignition is on and the vehicle is in a stationary position. This allows the driver or passengers enough time to press a hidden security button (depending on the vehicle) before the system is activated and the engine is once again allowed to begin.

Contrary to many other systems that simply stop the engine once the ignition switch is turned on The Ghost system is based on a specific controller and timer unit which will close the valve that cuts off fuel when it is activated after a set period of time, even if the ignition is still turned on! This delay time period needs to be long enough to allow the owner of the vehicle who was hijacked of the vehicle to move away from the scene of the hijacking and a sufficient distance from the stalled vehicle before the system can reactivate.

The Ghost comes with an additional level of security to prevent common hacking techniques used to gain access into modern cars, such as relay attacks and key range extension. The Ghost system communicates in a silent manner and does not emit signals that could be snatched by thieves with codes-grabbing or RF scanning technology.

The Ghost system also has the Service/Valet mode that allows your vehicle to be temporarily re-started and driven without the requirement of a PIN code. This is ideal for parking your car and need to be away for a short amount of time, for example to put groceries in the boot, or open a garage door. The system will end service mode according to speed and duration or through the simple PIN code input process and give you peace of mind that only YOU can use your vehicle!

Keyless Entry

With the rise of contactless car theft, many people are considering additional security options. This is particularly relevant for those who have put time or money to personalize their vehicle or own expensive vehicles. Immobilisers that are added to your vehicle can be an effective way to deter this type of theft since they prevent your vehicle from starting until the proper pin code is entered, along with your key fob.

Immobilisers are made to work with a variety vehicle circuits including those which control starter motors and fuel pumps. They also have the capability of shutting down the car alarm to draw attention and scare off any potential thieves.

These devices are directly connected to the engine control unit via the CAN data network. They prevent the thief from bypassing it by installing a new ECU or using key programmers. These immobilisers are put in place in a discreet manner and leave no trace in your vehicle. They are also not detected by hi-tech thieves' tools.

As opposed to other systems that require a particular application, or a tag that is worn on the person carrying it, a Ghost immobiliser can only be deactivated by pressing a pattern of existing electronic buttons on your steering wheel, door panel and centre console, allowing you to select a customized pin sequence. The pin can be changed as frequently as you'd like, meaning the device is as secure as a credit card. It can be even more difficult to break because it requires up to 20 press.

Ghost also offers the Valet/Service mode, which allows you to deactivate the system if your car is to be turned over for valet parking or services which allows it to operate within set parameters such as a 30mph speed limit, so you don't have to worry about your vehicle being driven recklessly. It can be activated using the original key or corresponding entry code.

This makes it the most effective and secure aftermarket CAN immobiliser available on the market. It is insurance approved by Thatcham as an optional accessory to your vehicle when installed by one of our accredited installers. The Ghost 2 immobiliser is also supplied with six QR fingerprint labels, an ISR contact card that contains your unique QR code, as well as an emergency code that is secure that are kept in your purse or wallet of your vehicle.