Ghost 2 Immobiliser Problems

The ghost immobiliser fitter 2 immobiliser, designed to protect cars from key cloning or hacking, is a small device that can be put in place without causing any damage to your vehicle. It prevents your vehicle from starting unless you press the correct sequence of buttons inside your vehicle similar to the password of the phone.

Stop/Start

Ghost Immobilisers prevent vehicles from being stolen by preventing the engine from starting until it has the correct PIN code. This is done with no modifications to the vehicle, and is completely undetectable to thieves. The unit communicates with the ECU on the CAN data bus to disable the vehicle. This system is very similar to the one that automobile manufacturers have used in their vehicles for a long time, however, the thief can't add a new key or utilize key relay technology to bypass it, as they can with factory fitted systems.

Ghost is compatible with all vehicles with an engine, which includes motorhomes, cars, vans and caravans, as well as bikes. The same system is compatible with electric vehicles. It's a great alternative to locking the steering wheel and wheel clamps, and can be installed with minimal effort.

When the Ghost is activated it will block all buttons in your car and stop the ignition from being started without the PIN code. This can be done via the Android or Apple mobile app or by manually entering the code using your key fob. If a code that is incorrectly entered, the app will show an indicator light and the Ghost will not allow the vehicle to start again. This is a great way to deter thieves. If the vehicle cannot be started and they are unable to get it started, they will leave.

The Ghost is small weatherproof device that is able to be concealed in the most difficult-to-access areas of your vehicle. Installation takes between 20 and 30 minutes for each vehicle. It is also very simple to remove should you choose to switch your vehicle or hand it in for valet parking or service. It is a fully TASSA (Tracking and Aftermarket Security Systems Association) insurance approved system that is recognised by some insurers. It also comes with a secure emergency Pin Code override and features the Service/Valet Mode which can be activated with an app button or by using your key fob.

Disarm

Ghost immobilisers like mechanical anti-theft devices that are able to be removed, are hidden in the car. Even if they were found, thieves would not be able to start the vehicle. They are virtually impossible to hack or bypass. A ghost immobiliser is capable of preventing key cloning and signal jamming and devices spoofing. These are methods that thieves employ to gain access to vehicles with standard immobilisers.

An immobiliser functions by sending a code to the ECU (electronic control unit). If the incorrect code is received and the vehicle does not start as the engine won't start. Although it is possible to disable the ghost immobiliser by using a software tool this is very laborious and time-consuming. The software must be installed and operated by a authorized installer.

The Ghost immobiliser, which is a tiny device, is hidden within the wiring loom of the vehicle. It is invisible to the naked eye once installed. It is not visible on diagnostic systems. There are no indicators with LEDs, and it does not communicate with the engine through the OBD port. It communicates silently through the CAN data circuit.

The system will not allow the vehicle to start unless it is provided with an input PIN number that is specified by the user. The code is entered by pressing buttons on the steering wheels and door panels as well as the central console. This is a much safer way to protect your car as it does not require keys or remote control.

In addition to this Ghost offers an option for service that can be activated using the application on your mobile phone. This will allow you to give your keys to a person for service or valet parking without entering the disarm sequence.

You should not remove the system from your Ghost yourself, regardless of whether it is in service mode. This could cause damage to the engine. It is recommended to contact a TASSA certified installer who will be able to remove the system safely and properly. Our newest GHOST II immobilisers also come with the QR fingerprint stickers that is hidden in various locations of your vehicle. these are linked to our global security register. In the event the system is removed and then sold on the black market this will connect it back to the original owner.

Anti-Hijack

Ghost Immobiliser 2 has a highly effective anti-hijack function. This system works like a smart key and is among the most secure ways to keep your car safe from theft. The Ghost system will automatically activate the hazard light and stop the car's engine when the ignition is turned on and the vehicle is stationary. This gives the driver or passenger time to press a hidden security button (depending on the vehicle) before the system is activated and the engine is once again allowed to start.

Unlike many competitor systems that simply stop the engine when the ignition is switched on and on, the Ghost system is based on a specific controller and timer unit that will shut off the fuel cut-off valve 14 in the event that it is activated within an agreed-upon time even if the ignition is still turned on! The delay time interval must be long enough to allow the owner of the vehicle who was hijacked of the vehicle to move away from the scene of the hijacking and a sufficient distance from the vehicle that is stalled before the system can reactivate.

The Ghost offers an additional layer of security that prevents common hacking methods used to gain entry into modern cars like relay attacks and key range extending. This is because the Ghost system is completely silent and does not emit signals that could be picked up by a thief using RF scanning or code grabbing technology.

The Ghost system also has a Service / Valet mode that allows your vehicle to be temporarily started and driven without the requirement of an PIN code. This is great for parking your car and need to leave it for a short amount of time, for example to put groceries in the boot or open a garage door, etc. The system will exit service mode depending on the speed and time or by using the easy PIN code entry process and give you peace of mind that only YOU are able to utilize your vehicle!

Keyless Entry

Many customers are now looking for extra security measures because of the increasing trend of car stolen with ghost immobiliser thefts using contactless technology. This is especially true for those who invested time and money into customising their vehicle or own rare/expensive cars. A supplementary immobiliser is an effective way to avoid this kind of theft because it can stop your vehicle from starting until the correct pin code is entered on your key fob.

Immobilisers are designed to intercept a variety of vehicle circuits, including those that control the starter motor and fuel pump. They can also disable the alarm for cars in order to attract attention and deter potential thieves.

These devices communicate with the engine control unit (ECU) through the CAN data circuit. They also they stop a burglar trying to get around it by putting in a new ECU or by using the key programmer. These immobilisers are installed discreetly and leave no marks in your vehicle. They are also unnoticeable by hi-tech thieves' tools.

In contrast to other systems that require a separate app, or a tag to be carried on the person carrying it, a Ghost immobiliser can only be deactivated by pressing a pattern of electronic buttons that are already present on your steering wheel, door panel and centre console, allowing you to choose a custom pin sequence. The pin can be changed as often as you want, which means it's as secure as a credit card. It can be more difficult to break due to the fact that it requires at least 20 presses.

Ghost also comes with the Valet/Service mode, which lets you deactivate the system if your car is going to be handed over to valet parking or services and allows it to operate within predetermined parameters such as a 30mph speed limit and you don't have to worry about your vehicle being driven recklessly. The system can be reactivated using the original key or corresponding entry code.

This makes it the most efficient and secure aftermarket CAN immobiliser available on the market and is fully insurance approved by Thatcham as an add-on to your vehicle when installed by one of our certified installers. The Ghost 2 immobiliser is also provided with six QR fingerprint labels as well as an ISR contact card with your unique QR code as well as a secure emergency code, all of which you keep in the wallet/purse of your vehicle.