Peugeot 308 Key Fob Replacement

Peugeot's 308 could be catching on a little, but it still feels appealing. It's not the most luxurious vehicle in its class, but it is a pleasant and peaceful driving experience.

Here at Coded Car Keys we are often asked to replace peugeot 308 key fobs. The following tips can aid in solving the issue whether it is intermittent, or constant.

Water Damage

When you accidentally leave your key fob in a pool or splash it with water when kayaking, swimming, canoeing, rafting or canyoning, it's likely to sustain water damage. The best method to prevent this from happening is to always keep it in a dry bag when you're out in the open or engaging in activities that require the fob to be exposed to excessive amounts of water.

It's also crucial to make sure the fob has completely dried before you open it up and then use it again. If you detect any odors from the fob (such as industrial fluid or windshield washer fluid), this is another indicator that it is submerged.

A wet circuit board can cause the battery to dump its charge, or even explode. If you can remove your keyfob 308 out of the water and turn it upside up and shake as much water as you can prior to opening the casing. After opening it, take off the battery and wipe the circuit board using an abrasive soaked in 90 percent isopropyl alcohol.

Other reasons why your Peugeot 308 remote keyless entry system could be unable to function could be due to a dead coin battery, receiver module issues signal interference, an electronic chip malfunctioning. If none of these causes the issue, try resetting the system by disconnecting the battery that is 12 volts for about 15 minutes.

Dead Coin Battery

Peugeot cars are equipped with a remote-start system that allows the driver to start the car from a distance while warming up or cooling down the vehicle prior to getting in. This feature is extremely helpful, especially during cold winter months. However, there are times when the remote stop system stops operating due to a range of reasons, such as a dead coin battery.

The coin-shaped battery contained within the key fob may last between two and four years based on the frequency with which it is utilized, the place it was purchased and how it is used. The date for use-by is typically printed on the packaging or listed in the instruction manual.

If the key fob has stopped working after exposure to clean tap water then you must remove the battery, then clean the electronic chip with a paper towel and isopropyl alcohol, and then dry it thoroughly before replacing it. If the key fob has been exposed to salty or soapy water, it may have caused the chip to be damaged. It is necessary to replace it.

If you're unsure whether the battery is damaged You can test its voltage using a multimeter that is connected to both the terminals for plus and minus. The voltage should be between 12-13 volts, but if it's lower, the battery needs to be replaced. You can also reset the onboard computer by disconnecting and reconnecting the 12 volt batteries in reverse order. (positive cable first then negative cable). The engine should then start.

Faulty Receiver Module

If you aren't seeing the "Key Detected", it could be the receiver module faulty. It's the part that sends an alert to the car when your key fob is activated it also acts as an immobiliser. It stops it from starting until the correct key is present.

It could be due to a number of causes, such as water damage or simply getting old. If the electronic chip inside your Peugeot 308 keyfob has been damaged due to dirty tap water, it could be because the keyfob was exposed it. In this instance, you'll have to remove it and clean it thoroughly using isopropyl or electronic cleaner. Once it's dry, you can put the battery back in and try again.

If the issue continues to persist, it's probably a good idea to visit an area Peugeot specialist or locksmith. They'll use a diagnostic tool to help pinpoint the issue and repair it for you.

Losing your Peugeot keys to your car can be an incredibly stressful experience. A professional auto locksmith can solve the issue in minutes. They can cut a new key and program it to your vehicle, ensuring that you're ready to get out on the road as fast as you can. Click here to locate locksmiths near you.

Faulty Electronic Chip

The electronic chip that is in the Peugeot 308 key fob plays an essential part in the remote control system. If it is damaged your car might not start, or you could receive a message saying "anti-theft active". If this occurs, the only way to fix the issue is to obtain a new key. Auto locksmiths with experience can provide this service in the shortest time.

The chip inside your peugeot 207 car key 308 key fob can become faulty due to water damage, sweat dirt, or any other cause. If your Peugeot key fob has been exposed dirty or soapy water, it needs to be cleaned immediately. You can clean the electronic component using an absorbent paper towel that has been soaked in isopropyl Alcohol. After that, you should allow the battery to completely dry.

Sometimes, a key fob can be inoperable due to radio interference. This could be due to other devices operate on the same frequencies as your Peugeot keyfob. This could be due to problems with the environment or objects in the vicinity of the vehicle. It is recommended that you visit a Peugeot dealer in the event of this issue.

The Peugeot 207/308 Key Fob is delicate and needs special care. It is essential not to drop or throw the key fob. If you lose something, try to locate it as soon as you can. You can reset the on-board computer by disconnection of the battery for a few minutes. Disconnect the negative cable before the positive.