How to Replace a Nissan Juke Spare Key

Nissan Juke is an attractive and fun hatchback that features unique engine design. It's noisy, but still fun to drive.

Replace the battery of the key fob of your Nissan Juke every two years, or when the battery is depleted. You can do it yourself, however you'll need a few tools.

Dead Coin Battery

If your Nissan Juke key fob has stopped functioning the first thing you should look at is the coin battery that is inside it. It could be dead and needs to be replaced. This is a quick fix that only takes several minutes. It's as easy as flipping the fob over and removing the small latch/release at the back. Replace the battery that was in use and ensure it's facing the bottom of the fob. Place the two halves of the fob carefully.

The fob must be cleaned if it has been exposed to water before you are able to insert a new battery. This can be done using paper towel and isopropyl alcohol or electronic cleaner, and then allowing it to dry completely before inserting the battery.

The key fob needs to be connected to the car in order to start it. This can be done by following the directions in the owner's manual, or using an OBDII scanner. The most likely reason the key fob was not working was because it wasn't paired. It is also possible that the fob has an issue with the chip, but this is not common. A new receiver module may be required in this scenario. If this is the scenario, the module will need to be replaced by an accredited technician.

Water Damage

The key fobs run on batteries and the batteries must be replaced every two years, or at the point that the car stops responding when push the "start" switch. The rubber seals on keys keep out water, but submerging the key fob in the pool or ocean can damage the electronic chip. If this happens you'll need an alternate key from Nissan or a locksmith.

If the key fob is equipped with a working chip It's likely that the computer has lost connection to it, and this could occur due to a variety of reasons. This can be resolved by restarting the car. If the "Key ID error" message persists, you will need to contact nissan juke key fob replacement for assistance.

The three most common causes of this issue are dead battery on the key fob or keys that are not programmed, and a damaged or defective key fob. The first two issues are easy to resolve, while the third is more difficult to fix immediately, but it is usually fixable with a bit of patience. Compare Nissan Key Replacement prices near you with WhoCanFixMyCar and schedule your repair online. You can read about the experiences of local Nissan dealerships, Nissan mechanics, and garages in a matter of seconds.

Faulty Chip

The key fob of your nissan key replacement near me Juke contains a special chip that transmits a message to the vehicle when you turn it. If the chip is damaged it could cause the key to cease functioning. If this is the case the issue will only be resolved by replacing the key. There are many reasons your Nissan Juke's keys could be faulty, including water damage or a dead coin battery or a damaged receiver module.

If your key fob stops working after a soak in the wash or bath, you must check the chip for water damage. Make sure the metal clips that hold it in place are secure and that the chip isn't exposed to water. If you spot any signs of water damage on the electronic component, take off the battery and clean it with isopropyl alcohol or electronic cleaner.

If the chip is damaged, you will need to visit your local locksmith or nearest dealership. In order to find a replacement, they will require the year, model and year of your vehicle. You will also need to write down the VIN (Vehicle Identification Number) so that the dealer or locksmith can identify the key you own. This will enable them to check the correct key code, and ensure that they cut the correct key.

Faulty Receiver Module

The key fob transmits a radio signal to your vehicle to perform various functions. It can open your trunk as you rush with groceries to your car or start your car by pressing an icon on the fob. It can also open your windows and turn the horn on in the event that you lock the keys in your car.

If the key fob does not work, it may be due to a glitch in the receiver module. The receiver modules are tuned to receive specific frequencies that correspond with the signals transmitted by the Nissan key fob. A faulty receiver module will prevent your car from responding to the signal sent by the key fob from Nissan.

Whatever way your Nissan key fob ends up getting damaged, it's recommended to have a spare in case the key is damaged or lost. A locksmith or dealership can program a spare key that works with your Nissan. This can help you avoid the hassles of losing your keys or locking them inside your car.

If your Nissan Juke's key fob was exposed to rain or clean tap water, you could fix the problem by cleaning it with isopropyl or electronic cleaner. If the chip has become damaged, you'll have to purchase a new keyfob which can be programmed for your vehicle by a locksmith or dealer.